Sprint Nextel 1733 manual Using the Wall Mount Adaptor

Page 15

USING THE WALL MOUNT

ADAPTOR

1.Position the wall mount bracket on the Base Unit.

Line up the tabs on the wall mount adaptor with the holes on the bottom of the Base Unit . Snap the wall mount bracket firmly in place.

1

2.Mount the Base Unit on the wall. Position the Base Unit so the mounting studs will fit into the holes on the bottom of the Base Unit. Position the power cord to extend down the wall the phone is to be mounted on. Slide the Base Unit down on the mounting studs until it locks into place.

3.Plug in the AC adaptor.

Plug the AC adaptor into an electrical outlet, and the DC connector to the back of the Base Unit. If the Handset battery pack has not been charged previously, place the Handset in the Base Unit cradle, and allow it to charge for 16 hours.

4.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end, Insert one of the plugs into the jack qn the bottom of the Base Unit. Insert the other end of the plug into the wall jack.

Image 15

Contents Spread Spectrum Cordless Telephone Table of Contents Table of Contents O N E Book Page Introduction Special FeaturesParts Checklist Sprint National Help Desk at FCC PartFCC Part IC Industry Canada Page Sprint National Help Desk at a ITS Impossible to OVER- Charge the Battery Pack To Charge the Battery PackDesk at Replacingthe Handset Battery PackTonupulse Selection Setting UP AC Power AdapterSetting Ringer Pack BeforeuseUsing the Wall Mount Adaptor Handset Layout Page From the Handset Making CallsRinger Control Volume ControlAnswering Calls TemporarytoneRedial with the Handset -ON OFF Hook HoldPress PHONE. The Sprint From the Handset when Handset OFF or on HookRedial with the Handset OFF on Hook Intercom Between Handset and BaseFrom the Base when From the Handset when Handset on or OFF HookFrom the Base when SpeakerphoneoffConference Reviewing Caller ID RecordsMemory Dialing Flash RDL Redial MEM Memory Set ToneIPulse Del delete MSG Icon Save DlAL DEL DeleteCall Waiting ID Caller ID Call WaitingNEW Phone Book Records Editing Phone Book RecordsXX location displayedis itsorigi- nal location Adding NEW Phone Book RecordsR s Page Page Delete MSG Icon Answer OFFTo purchase a Headset, call Sprint National Help Desk at OperationBelt Clip Icon. Press Enter Messagewaiting Indicator for use with VoicemailCall is answered Custom PAY-PER-USE PPU FeaturesLOW Battery Indication Check AC Power IndicationAvoid Water CLEAN~NGYOUR TelephoneTaking Care of Your Telephone Avoid RoughtreatmentHandset does not Ring When YOU Receive a Call Phone Doesntwork AT ALLNo Dial Tone Required Limited WarrantyFrequency Control WeightPower Requirements Specifications are TYPI- CAL and MAY Change Without NoticePage