Oricom TP150 manual Setting Up, Setting the contrast, Setting the Time and Date

Page 8

4 Setting Up

4.1 Setting the contrast

1.Press the MENU button. The display shows “LCD CONTRAST”.

2.Press the CALL BACK button. The display shows the current contrast setting with values between 1 and 5.

3.Press or to select the contrast level and confirm with CALL BACK button.

4.The display now shows to “TIME/DATE”, you can refer to next section to set the time and date or press CID button to exit the set-up mode.

4.2 Setting the TIME and DATE

1.Press and release the MENU button until “TIME/DATE” is shown.

2.Press the CALL BACK button. The display shows “ENTER TIME” and the hours digit is flashing.

3.Select the current hour using the or and confirm with CALL BACK button. The minutes will now flash in the display.

4.Select the required minutes using the or and confirm with CALL BACK button. The display now shows “ENTER DATE” and the month digit is flashing.

5.Select the current month using the or and confirm with CALL BACK button. The day will now flash in the display.

6.Select the current day using the or and confirm with CALL BACK button.

7.Exit the set-up mode using the CID button.

4.3Setting country (AUSTRALIA/NEW ZEALAND) mode The factory preset is AUS.

1. Press and release the MENU button until AUS /NZ is shown.

2. Press the CALL BACK button.

3. Select your location (AUS or NZ) by using or and confirm with CALL BACK button.

4. Press CID to exit the set-up mode.

Note: Australia Recall/flash time is 100ms. New Zealand Recall/flash time is 600ms, the unit is now set up to insert 0/00 when receiving CID log in accordance with Telecom NZ requirements.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Care Phone with Emergency Call Function TP150 General Information Page REN RN for New Zealand Caller IDLocation of controls N13134Installation Installing batteries supplied in the phoneConnecting the mains power supply Connecting the telephoneWall Mounting Setting the Time and Date Setting UpSetting the contrast Receiver Volume Control Receiver Tone Volume ControlRinger Volume Control Voice PromptsTelephone Operation Making a callReceiving a Call Pre Dialing a CallSpeaker Volume Control Network Message Waiting IndicatorLast number Redial Call waiting Recall buttonPhone Book To mute the microphonePause Storing numbers in the M1 & M2 one touch memoriesPage Overview How to enter namesTo review the Phone Book Memory To dial a number from the Phone Book To Edit Phone Book Memories To Delete the Phone Book MemoryEmergency Call feature Emergency MessageTo record your emergency message To check your emergency messageTo activate the Emergency Call function Caller ID Receiving a Call Can be stored up to 64 callsView the Caller ID Memory Deleting Numbers from the Caller ID MemoryCall Back Redial from the Caller ID Memory Copy from the Caller ID to the Phone BookImportant Information Periodic testingTesting the remote pendant battery Battery Backup on the phone base Consumer Support and TroubleshootingAustralia New ZealandExclusion and limitation of liability Cleaning and careWarranty Information 2LMB95YY
Top Page Image Contents