Oricom TP150 manual To activate the Emergency Call function

Page 18

7.5 To activate the Emergency Call function:

1.Press and hold the button on the pendant or the SOS emergency button on the telephone for three seconds. The telephone will beep loudly for 15 seconds. (If during this time the emergency SOS button on the phone, or the button on the pendant is pressed for more than three seconds, the emergency call will be cancelled. If the key is not pressed, the telephone will dial out the emergency numbers automatically in speakerphone mode.

2.The telephone dials out the first emergency number (stored in the phone book emergency location 1), and then announces the emergency message continuously.

If during 60 seconds the called party acknowledges the call by pressing 0 on their phone, the speakerphone will be activated for 3 minutes.

If 0 is not pressed within 60 seconds, the TP150 will terminate the call, then after a further 30 seconds redial the next emergency number automatically in speakerphone mode.

WARNING

1.If NO emergency numbers have been programmed, the telephone will not dial anything. It will just beep loudly when the SOS button on the phone or the button on the pendant is pressed.

2.The pendant must be within the range of the telephone to activate the emergency feature. You should check that there are no structural obstacles, heavy concrete walls between the pendant and the telephone.

3.When the red button on the pendant is pressed, the red light (LED) will light up for as long as the key is pressed. If the led does not light up it is necessary to replace the battery.

4.To cancel the emergency feature, press and hold the SOS button on the telephone or the pendant for more than three seconds.

5.The emergency feature will automatically stop when all the emergency numbers have been dialled or if the receiver presses 1 and 2 after the 0 key. (The reason for interrupting the call after 3 minutes is for safety in case a receiving party presses 0 but for any reason is unable to receive the message, in case of mobile phone drop out for example).

6.The receiving party must use a tone dialing phone, (standard feature on most telephones) to press “0”.

17

Image 18
Contents Care Phone with Emergency Call Function TP150 General Information Page REN RN for New Zealand Caller IDLocation of controls N13134Connecting the mains power supply InstallationInstalling batteries supplied in the phone Connecting the telephoneWall Mounting Setting Up Setting the contrastSetting the Time and Date Ringer Volume Control Receiver Volume ControlReceiver Tone Volume Control Voice PromptsReceiving a Call Telephone OperationMaking a call Pre Dialing a CallLast number Redial Speaker Volume ControlNetwork Message Waiting Indicator Call waiting Recall buttonPause Phone BookTo mute the microphone Storing numbers in the M1 & M2 one touch memoriesPage How to enter names To review the Phone Book MemoryOverview To dial a number from the Phone Book To Edit Phone Book Memories To Delete the Phone Book MemoryTo record your emergency message Emergency Call featureEmergency Message To check your emergency messageTo activate the Emergency Call function Caller ID Receiving a Call Can be stored up to 64 callsCall Back Redial from the Caller ID Memory View the Caller ID MemoryDeleting Numbers from the Caller ID Memory Copy from the Caller ID to the Phone BookPeriodic testing Testing the remote pendant batteryImportant Information Australia Battery Backup on the phone baseConsumer Support and Troubleshooting New ZealandCleaning and care Warranty InformationExclusion and limitation of liability 2LMB95YY