USE
Charging an empty battery
These instructions apply when Auto Mower is new, or after a long period of storage.
If the Auto Mower has been used recently it does not need to be started in the charging station, see the chapter “Start and stop”.
Place the Auto Mower in the charging station for 60 minutes
The charging pins must be in contact with the charging station contact plates. Set the Auto Mower power switch to “STOP” for the battery to be charged gently.
Set the power switch to on
The beep indicates that the battery has enough power to run the electronics.
Enter code (*code #)
A short beep is heard and LED 1 lights each time a button on the keypad is pressed.
Incorrect entry |
A long beep is heard and LED 6 flashes. OR |
Code accepted
A short beep is heard and LED 1 lights on the keypad. Lower the cover.
Auto Mower continues to charge
Auto Mower signals 2 beeps/10 seconds (LED 1 flashes) and starts as soon as the battery is fully charged.
Note the battery is not charged on delivery. The battery is now charged using a considerably higher current than during trickle charging. It normally takes
Incorrect code
A long beep is heard and LED 6 flashes. The keypad is now switched off. You must wait 2 minutes before making a new attempt.
Contact your dealer if you have lost your code.
12 – English
