Husqvarna Robotic Lawn Mower manual Observation, Trouble Shooting, Possible cause, Action, English

TROUBLE SHOOTING

Observation	Possible cause	Action
The Auto Mower goes	If this only happens at certain places on	Check by moving the position of the
outside the working area	the lawn it may be caused by metal	boundary wire.
	objects (fencing, iron strengthening bars
	etc.) or cables buried nearby.
	The working area is sloping too steeply.	Ensure that the boundary wire has been
		laid in accordance with the installation
		instructions.
	The boundary wire has been laid wrongly	Ensure that the boundary wire has been
	around an “island”.	laid in accordance with the installation
		instructions.
	The boundary wire has been laid too	Ensure that the boundary wire has been
	close to the edge of the area that you	laid in accordance with the installation
	want to use as the working area.	instructions.
Uneven mowing result	The Auto Mower is working too few	Lengthen the working time, see “Settings”.
	hours each day.
	The working area is too large.	Try reducing the size of the working area
		or lengthening the working time, see
		“Settings”.
	The blades are blunt.	Change all three blades, to keep the
		cutting disc balanced.
	Grass is too long in relation to the set	Raise the mowing height. Gradually lower
	cutting height.	the cutting height until the desired height
		has been achieved.
	Clumps of grass clippings on the cutting	Check that the protective plate and cutting
	disc or around the motor shaft.	disc rotate freely and easily. If not, the
		protective plate and possibly the cutting
		disc must be removed to clean off grass
		and foreign objects.
The Auto Mower works at	The Auto Mower clock requires setting.	Set the clock, see “Settings”.
the wrong time
	The mowing start and stop times are	Set the mowing start and stop times
	incorrectly set.	again, see “Settings”.
The Auto Mower vibrates	Unbalanced cutting disc or damaged	Inspect the blades and replace them if
	blades.	necessary.
Auto Mower runs around	Auto Mower is searching for the charging	No action. The cutting disc does not rotate
but the cutting disc does	station.	when the mower is searching for the
not rotate.		charging station.
The mower runs for	Grass or a foreign object is slowing down	Remove and clean the cutting disc and
shorter periods than usual	the cutting disc or protective plate.	protective plate.
between recharging.
Mowing and charging	This is normal behaviour when the
times are both shorter	temperature is high (gradually increasing
than usual.	above 25°C).

18 – English