Oricom pro600 DECT manual HS2, Handset, HS1 Conf Activates conference call, End conference call

Page 13

Conference calls

You can hold a conference call between 1 external and 2 internal callers.

HS1: <INT,	, eg 2	During an external call, dial the
		number of the required handset

HS2:	Accept the internal call on the other
	handset

HS1: Conf	Activates conference call

HS1 or HS2:	End conference call

Handset registration

You only need to register a handset that has become deregistered from the base or if you have purchased a new handset.

New additional handsets must be fully charged before you attempt to register them.

Telephone

At the base

10 sec		,	Activate registration mode
At the handset
,	or	,	Open the menu, select "Handset"
or	,	,	Select "Registration", "Register"
or	,	,	Select 1,2,3 or 4
,		,	Enter the PIN code and confirm

Handset deregistration

You will only need to de-register a handset if you decide that you have too many handsets registered or your handset develops a fault and you need to replace it.

, or ,

Open the menu, select "Handset"

or , , , Select "Registration", "De-register"

,	,	Enter the PIN code and confirm
,		Enter the handset number and confirm

11

Pro_600_800.indd 11

2008-11-11 16:17:36

Image 13

Contents Professional Series Table of Contents White pages directory Handset. Slide the battery door firmly into place Installation and ChargerGetting Started Select your countryIf any of these are missing, please contact Oricom directly Purchasing additional handsetsOGM Pro600 Operating the Telephone Operating the TelephoneSec Cordless handsetNavigating in the menu Standby modeSelect New entry Confirm itTelephone TelephoneDeactivate handsfree mode Adjusting the Handsfree volume Boosting the receiver volumeChain dialling Switches the microphone off Mute HS2 Activate registration modeHandset HS1 Conf Activates conference callUsing the menu Using the menuOutgoing calls User profiles cannot be selected in Handsfree modeFor the call Select Ringer volume Handset Ringing volumeVolume Current setting is shown You can also adjust the equaliser settings when youEnter new name and confirm it Level Current setting is shownSelect Keypad Beep ContrastSelect Select base Auto Current setting is shownSelect NZ Caller ID Base Ringing melody Base Ringing volumeShaker Select ShakerDate/Time Open the Menu, select Time Select Date and Time Set Alarm Open the Menu, select Alarm Select Set alarmSelect Set time format ConfirmPhone Book Phone Book Caller ID Caller IDOption Select Delete all Deleting a single calls list entryTake two different calls at the same time Rec. and Answer Only Using the Answering Machine Pro800 OnlyPress to end your recording Check your OGM Current OGM is announcedRecord a memo Set the date and time SecPlay/Pause StopMsgs Listen to your messages/memos via the handsetPress the key to return to standby Memory Full Using Remote Access Pro800 Only Remote Access Pro800 OnlyPIN Code for remote access Changing the PIN codeSwitch to remote access Answer On/Answer mode1st OGM Recording Delete current messageAdvanced Settings Advanced SettingsTroubleshooting TroubleshootingTechnical Properties Technical propertiesDefault settings Default settingsTelephone Answering Machine Warranty Australia Maintenance/GuaranteeCustomer Support REN RN for New Zealand Index IndexIndex Index User Profiles Warranty Australia Australia Customer Support