Oricom pro800 DECT, pro600 DECT Using Remote Access Pro800 Only, PIN Code for remote access

Page 28

Using Remote Access (Pro800 Only)

Remote Access (Pro800 Only)

You can call your answering machine from any TouchtoneTM phone or mobile phone whilst you are away from home to listen to your messages.

PIN Code for remote access

A 3-digit PIN code is required for remote access to your answering machine. The default code is "000" but for security reasons you should change this to a code personal to you.

Changing the PIN code

2 sec PINCODE					Announces the current security code
(Under base)					and prompts for 1st digit

					Select the 1st digit

Confirm the digit

Select the 2nd digit

Confirm the digit

Select the 3rd digit

Confirm the digit. Your new security code will be announced.

Press the key at any time to exit from changing the PIN code and return to standby. The PIN code will then remain unchanged.

Call in to check your messages

Dial your own phone number and wait until the answering machine picks up the call.

2 x, ,	Switch to remote access and enter your
	3 digit PIN code after the voice prompt.

If you enter your PIN code incorrectly, the answering machine will hang up the call.

If you enter your PIN code correctly you can now remotely control your answering machine by using the digits on the keypad.

26

Pro_600_800.indd 26

2008-11-11 16:17:43

Image 28

Contents Professional Series Table of Contents White pages directory Installation and Charger Handset. Slide the battery door firmly into placeGetting Started Select your countryPurchasing additional handsets If any of these are missing, please contact Oricom directlyOGM Pro600 Operating the Telephone Operating the TelephoneSec Cordless handsetStandby mode Navigating in the menuSelect New entry Confirm itTelephone TelephoneDeactivate handsfree mode Adjusting the Handsfree volume Boosting the receiver volumeChain dialling Switches the microphone off Mute Activate registration mode HS2Handset HS1 Conf Activates conference callUsing the menu Using the menuOutgoing calls User profiles cannot be selected in Handsfree modeFor the call Handset Ringing volume Select Ringer volumeVolume Current setting is shown You can also adjust the equaliser settings when youLevel Current setting is shown Enter new name and confirm itSelect Keypad Beep ContrastSelect Select base Auto Current setting is shownSelect NZ Caller ID Base Ringing volume Base Ringing melodyShaker Select ShakerSet Alarm Open the Menu, select Alarm Select Set alarm Date/Time Open the Menu, select Time Select Date and TimeSelect Set time format ConfirmPhone Book Phone Book Caller ID Caller IDOption Select Delete all Deleting a single calls list entryTake two different calls at the same time Using the Answering Machine Pro800 Only Rec. and Answer OnlyPress to end your recording Check your OGM Current OGM is announcedSet the date and time Sec Record a memoPlay/Pause StopMsgs Listen to your messages/memos via the handsetPress the key to return to standby Memory Full Remote Access Pro800 Only Using Remote Access Pro800 OnlyPIN Code for remote access Changing the PIN codeAnswer On/Answer mode Switch to remote access1st OGM Recording Delete current messageAdvanced Settings Advanced SettingsTroubleshooting TroubleshootingTechnical properties Technical PropertiesDefault settings Default settingsTelephone Answering Machine Warranty Australia Maintenance/GuaranteeCustomer Support REN RN for New Zealand Index IndexIndex Index User Profiles Warranty Australia Australia Customer Support