Oricom pro800 DECT, pro600 DECT manual Telephone

Page 10

Telephone

Telephone

Making a call

Enter the phone number (max. 24 digits)

Following incorrect input, press to delete the last digit

Dial the phone number

It is also possible to press the external call button first to obtain dialling tone. The digits entered will then be dialled immediately. It is not possible to correct wrong digits individually using this dialling procedure.

End a call

End the call

Take a call

or

Take the call

Redial

Your telephone stores the last 10 telephone numbers dialled (max. 24 digits each).

Open the redial list

or , or

Select an entry and dial the number

8

Calling back missed calls

Your telephone stores the last 30 incoming calls in the calls list.

Open the calls list

or , or

Select an entry and dial the number

Dialling phone numbers from the phone book

There must be phone numbers stored in the phone book. See page 19. Your telephone can store up to 200 name and number entries in the phone book.

Open the phone book

or , or

Select an entry and dial the number

Quick dial

Phone numbers must have been stored as quick dial numbers. See page 7.

M1 or M2

Press the required quick dial button

 

 

or

Dial the number

 

 

Pro_600_800.indd 8

2008-11-11 16:17:34

Image 10
Contents Professional Series Table of Contents White pages directory Getting Started Installation and ChargerHandset. Slide the battery door firmly into place Select your countryPurchasing additional handsets If any of these are missing, please contact Oricom directlyOGM Pro600 Sec Operating the TelephoneOperating the Telephone Cordless handsetSelect New entry Standby modeNavigating in the menu Confirm itTelephone TelephoneDeactivate handsfree mode Adjusting the Handsfree volume Boosting the receiver volumeChain dialling Switches the microphone off Mute Handset Activate registration modeHS2 HS1 Conf Activates conference callUsing the menu Using the menuOutgoing calls User profiles cannot be selected in Handsfree modeFor the call Volume Current setting is shown Handset Ringing volumeSelect Ringer volume You can also adjust the equaliser settings when youSelect Keypad Beep Level Current setting is shownEnter new name and confirm it ContrastSelect Select base Auto Current setting is shownSelect NZ Caller ID Shaker Base Ringing volumeBase Ringing melody Select ShakerSelect Set time format Set Alarm Open the Menu, select Alarm Select Set alarmDate/Time Open the Menu, select Time Select Date and Time ConfirmPhone Book Phone Book Caller ID Caller IDOption Select Delete all Deleting a single calls list entryTake two different calls at the same time Press to end your recording Using the Answering Machine Pro800 OnlyRec. and Answer Only Check your OGM Current OGM is announcedPlay/Pause Set the date and time SecRecord a memo StopMsgs Listen to your messages/memos via the handsetPress the key to return to standby Memory Full PIN Code for remote access Remote Access Pro800 OnlyUsing Remote Access Pro800 Only Changing the PIN code1st OGM Recording Answer On/Answer modeSwitch to remote access Delete current messageAdvanced Settings Advanced SettingsTroubleshooting TroubleshootingTechnical properties Technical PropertiesDefault settings Default settingsTelephone Answering Machine Warranty Australia Maintenance/GuaranteeCustomer Support REN RN for New Zealand Index IndexIndex Index User Profiles Warranty Australia Australia Customer Support