Oricom eco5100 Series Answering machine Ring delay Setting, Answering machine PIN number Setting

ANSWERING MACHINE OPERATION

6. Press	or	MEMO key to select minutes. Voice prompt at each selection will
be heard.

7. Press key to confirm setting and go back to standby or off mode.

Answering machine Ring delay Setting

This setting is used to set how quickly the answering machine answers an incoming call.

Default number of rings -3

1. Press and hold 2-9/GS key (bottom of base) for 2 seconds.

“Please set rings” will be heard followed by a short beep, after a pause then prompt current rings.

2. Press or MEMO key to select item. Voice prompt at each selection will be heard. There are 2-9 and TS mode (Toll saver) for you to select.

3. Press 2-9/GS key to confirm setting and go back to standby or off mode.

Note: If you have a fax machine connected to the same line and the fax is set to "AUTO-ANSWER" you should set the ring delay on your eco5100 to "9" and your fax machine to "2".

Tip: Toll Saver is a cost effective way to manage your messages when accessing your answering machine remotely. When toll saver (GS) is selected, your an- swering machine will pick up the call after 2 rings if you have new messages or 5 rings if you have no new messages.

Answering machine PIN number Setting

A 3-digit security code is required for remote access to your answering machine. The default code is “321” but for security reasons you should change this to a code personal to you.

1. Press and hold CODE key (bottom of base) for 2 seconds. You will hear “Please set security code” and the first digit, eg: 3.

27