DESKTOP INSTALLATION
6 | 3 | 7 |
|
|
5
1
2 T/P switch
Two Lines on a Single Modular Jack
1.Attach the base plate.
2.Set the T/P switch to T for
3.Raise the base antenna.
4.Set the RING switch to ON so the handset rings for incoming calls.
5.Plug the telephone line cord into the L1 or L2 jack located on the back of the phone and into a dual line modular jack.
6.Plug the power supply cord into the base and into an AC outlet.
7.Place handset in the base to charge for 12 hours. The CHARGE/PAGE light comes on indicating that the battery is charging. If you don’t charge the handset battery properly (for 12 hours) when you first set up the phone, the battery’s
NOTE: Use only the Thomson
4