RCA 2-9925 manual Wall Mount Installation

Page 8

WALL MOUNT INSTALLATION

Two Lines on a Single Modular Jack

1.Remove the handset hook; turn it upside down, and put it back in the slot. You need to do this so the handset doesn’t fall out of the base.

2.Plug the telephone line cord into the L1 or L2 jack on the back of the unit. Wrap the extra line cord around the cord wrap on the bottom of the base and then thread it through the top of the base plate.

3.Connect the power supply adapter to the POWER 9V DC jack on the back of the unit. Then thread it through the bottom of base.

4.Reverse the direction of the base plate and replace it by putting the tabs into the slots on the top of the unit first and snapping the bottom tabs into place.

5.Plug the telephone line cord into the dual line modular jack.

6.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (Wall plate not included.)

7.Set the T/P switch to T if you have touch- tone service or to P (pulse) if you have rotary dial service.

8.Set the RING switch to ON so the handset rings for incoming calls.

9.Plug the power supply adapter into an AC outlet and raise the antenna.

10.Place the handset in the base to charge for 12 hours. The CHARGE/PAGE light comes on. If you don’t charge the handset battery properly (for 12 hours) when you first set up the phone, the battery’s long-term performance will be compromised.

6

1

10

LINE 1

LINE 2

CHANRGE/

PAGE

PAGE

2

3

4

5

9

Image 8
Contents 900MHz Two-Line Cordless Telephone User’s Guide FCC Registration Information Table of Contents IntroductionAC power adapter Getting StartedBefore YOU Begin Two telephone line cordsInstallation Options Line 2 LineDesktop Installation P switchEach Line on a Separate Modular Jack Wall Mount Installation Each Line on a Separate Modular Jack Talk button Line 1 and Line 2 indicator lights Cordless Phone BasicsMaking a Call Line 2 button Line 1 buttonReceiving a Call Flash ButtonTalk button Flash buttonVOL Volume Switch VOL switch on the side of the handsetRING/PWR switch LOW indicator lightTone button Mute button Mute ButtonTemporary Tone Hold Button Conference ButtonPaging the Handset Hold buttonAdvanced Features Memory FeatureChannel Button Chan Chan buttonChanging a Stored Number Dialing a Stored Number Connecting a Headset To the Handset Headset plug 2.5mm Headset jackConnecting the Belt Clip Slot forChanging the Battery Troubleshooting Guide You connect the headsetProblem Solution Cannot hear General Product Care Causes of Poor ReceptionService Accessory Order Form 2425Accessory Order Form Index Ring OFF on 10 ToneLimited Warranty For how long after your purchase