RCA 2-9925 manual Each Line on a Separate Modular Jack

6 3 7

5

1

2 T/P switch

Each Line on a Separate Modular Jack

1.Attach the base plate.

2.Set the T/P switch to T for touch-tone service, or P for pulse (rotary) service. If you don’t know which type of service you have, check with the phone company.

3.Raise the base antenna.

4.Set the RING switch to ON so the handset rings for incoming calls.

5.Plug one of the telephone line cords into the L2 jack and into a single line modular jack. Connect the remaining phone cord to the L1 or L2 phone jack located on the back of the phone and into a single line modular jack.

6.Plug the power supply cord into the base and into an AC outlet.

7.Place handset in the base to charge for 12 hours. The CHARGE/PAGE light comes on indicating that the battery is charging. If you don’t charge the handset battery properly (for 12 hours) when you first set up the phone, the battery’s long-term performance will be compromised.

5