RCA 21011 manual Installing the Handset Battery

Page 11

INSTALLING THE HANDSET BATTERY

NOTE: You must connect the handset battery before use.

1.Push down on the top of the battery compartment cover (located on the back of each handset) and remove the cover.

2.Lift the battery pack and connect it's plug to the jack inside the compartment.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the compartment as shown in the illustration.

3.Close the battery compartment by pushing the cover up until it snaps into place.

4.Place the handsets in the charging cradles.

Allow handsets to charge for 12 hours prior to first use. If you don’t properly charge the handsets, battery performance is compromised.

BATTERY

BLACK WIRE

PRESS DOWN

 

FIRMLY

RED WIRE

11

Image 11
Contents 21011 Notification to the LocalTelephone Company Equipment Approval InformationTable of Contents Savethese Instructions Introduction FeaturesYour Caller ID Call Waiting phone allows you to Base Layout Handset and Charge Cradle LayoutMake sure your package includes the items shown here Before YOU BeginImportant Installation Information Installing the Phone Installing the Handset Battery Okexit Telephone SetupLanguage Areacode Exit EnglishSetlanguage 1ENG 2FRA 3ESP Language ContrastContrast SET Areacode AreacodeRingertone Ringer Tone Languageareacode AreacoderingertoneSET Tone / Pulse 1 Tone 2 Pulse Okexit Ringer ToneTone / Pulse Time Ringertone Registration ToneHold Basepage Wait for Beep Confirm Registration ?Handset Registered Handsetneedsregister Registrationhandset ?Menudir Billsmith HandsetEnter Name Billsmith DE-REGISTER Handset 1 ? Movenear TobaseDeregistration Walkietalkie Confirm Deregistration ? Handset DeregisteredDeregistration Walkie Talkie Walkie Talkie Enable ?Walkie Talkiewalkie Talkie ENABLEDHANDSET1EXIT Walkie Talkie With Handset # Handset # DisabledWalkie Talkie HANDSET# Walkie Talkie Extension ?SET Time TONE/PULSE TimeDefaultsetting Defaultsetting LanguageDefaultsetting YES 2NO DefaultsettingBasic Operation Making a Call Handset Name Handset Ringer onNEW CALL00 Ringer High HI 2LOW 3OFFRinger LOW Conf Trans Exit Line on HoldMute Hold DIR Line ActivePaging Extension ? Paging HandsetLine on Hold Extension ? Pagingfrom HANDSET1Mute on Pagingfrom HandsetPAGING/LINEONHOLD Steve Temporary Tone Dialing Mute PagingPagingfrom Receiving AN Intercom Call Line on HOLD/INTERCOM PAGING/LINEONHOLDHANDSET1 Memory Select MemoryEdit DEL Exit Menu DIR Enter TelnumbrStoring a Redial Number Delete ? Peter ChanDialing a Stored Number Handset 000000000000000 Receiving and Storing Call Records You may transfer a Caller ID record to your phone ’s memory Save DEL ExitReplace MEMO? Eleven digits Deleted Delete Call ID?Delete ALL ? No CallsReplacing the Battery Headset and Belt Clip Installation Incomplete Data Display MessagesTroubleshooting Guide Handset Sound SignalsPage Caller ID Solutions General Product Care Causes of Poor Reception ServiceIndex Page Orcompletethisorderform For how long after your purchase Limited Warranty