Radio Shack TAD-705 owner manual Setting the DAY, Time and Date, Setting the Number of Rings

Page 10

43-705.fm Page 10 Tuesday, May 23, 2000 8:54 AM

2.Press DIAL twice. 000 and SET AREA CODE appear. The first 0 flashes.

3.Repeatedly press :/8 until the first

digit of your area code appears, then press 9/; to the second digit. The second 0 flashes.

Note: If you make a mistake, repeatedly press 9/; to move the cursor to the position of the incorrect digit then re- enter the code.

4.Repeat Step 3 to set the second and third digits of your area code.

5.Press DIAL then press STOP to return to the time display.

SETTING THE DAY, TIME AND DATE

To avoid losing the day and time settings if AC power fails, we recommend you install a backup battery before you set the day and time (see “Installing a Backup Battery” on Page 7).

Follow these steps so the TAD can record the correct day and time each message and memo is recorded.

Note: If you do not complete each step with- in 8 seconds, the TAD exits setup. Start again at Step 1.

1.Hold down STOP until the TAD beeps once.

2.Repeatedly press DIAL until SUNDAY appears.

3.Repeatedly press :/8 to select AM or

PM.

4.Press 9/;. The hour digit flashes.

5.Repeatedly press :/8to set the cor- rect hour.

6.Repeat Steps 4 and 5 to set the minute, month, date, and the day of the week.

7.Press DIAL then press STOP to return to the time display.

SETTING THE NUMBER OF RINGS

Set the ring select switch to 2, 4, 7, or TS (Toll Saver) to set how long the TAD waits before it answers a call (2 rings, 4 rings, 7 rings or toll-saver).

If you plan to check your messages by long distance, set the ring select switch to TS.

10

Preparation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 9 Page 11
Image 10
Page 9 Page 11
Contents TAD-705 Memory Speakerphone Contents Troubleshooting Caller ID OperationFCC Statement Read this Before InstallationImportant Caller ID Information FCC Wants YOU to KnowFeatures Telephone FeaturesCaller ID Features Programmable Remote Operation SecuriPreparation Installing a Backup BatteryMounting the TAD On a Desk On a Wall or Wall PlateSetting the Display Contrast Setting the Dialing ModeSetting the Ringer Setting the Long Distance CodeSetting the DAY, Time and Date Setting the Number of RingsAdjusting the Volume Switching Between the Handset and the SpeakerphoneTelephone Operation Using Hold Using RedialUsing Flash Using PrivacyEntering a Pause A Memory Number Storing a Number in MemoryStoring Numbers from Caller ID Records Reviewing Memory NumbersDialing a Memory Number Connecting AN Optional HeadsetTesting Stored Emergency Num- bers Chain-DialingRecording the Outgoing Messages Setting the TAD to Answer CallsTAD Operation Checking the Outgoing MessagesPlaying Messages Incoming Message RecordingAnnounce Only Recording a Memo Recording a ConversationScreening Calls Using Call BreakthroughDeleting Messages Changing the CBT CodeRemote Command List Using the TOLL-SAVERUsing Remote Commands Changing the Remote Operation Security CodeHave no announcement two Caller ID Operation Caller ID Messages Reviewing Caller ID RecordsDeleting Call Records VIP Call ListDialing Number Selections Setting the VIP AlertUsing Dial Different Area CodeFm Page 25 Tuesday, May 23, 2000 854 AM Troubleshooting Problem SuggestionResetting the TAD CareLimited One-Year Warranty
Top Page Image Contents