• the TAD's memory is full
The recorded conversation is stored as a message (see “Playing Messages” on Page 16).
DELETING MESSAGES
To delete a specific message, press DELETE while the message is playing. The TAD beeps and deletes the message, then plays the next.
To delete all messages, stop playback and hold down DELETE until dEL ALL appears, then press 9/;.
The TAD does not delete new messages. If you hold down DELETE then press 9/; to delete only new messages, the TAD sounds four beeps.
SCREENING CALLS
To screen calls, let the TAD answer them. TAD IN USE appears.
TELEPHONE ANSWERING SYSTEM
AM | CALL |
NEW | |
O M1 O M2 | ANS ON |
CALLER ID
DELETE | / | / | DIAL |
Listen to the caller's message through the TAD's speaker. To adjust the volume, slide SPEAKER VOL MIN/MAX on the right side of the TAD (see “Adjusting the Volume” on Page 11).
If you decide to answer the call, pick up any phone on the same phone line as the TAD. The TAD stops recording and resets to an- swer the next call.
If you do not want to take the call, let the TAD finish recording the caller's message.
Note: If you answer the phone just as the TAD answers, the TAD might not stop play- ing the outgoing message. If this happens, press STOP.
USING CALL
BREAKTHROUGH
If you screen your calls but want to know when calls come in from certain people, give them your Call Breakthrough (CBT) Code.
When a caller enters the CBT code during the outgoing message, the TAD alerts you with a series of loud beeps for 35 seconds. To answer the call, pick up the handset. If you do not answer, the caller can leave a message after the outgoing message plays.
Changing the CBT Code
The CBT code is preset to 168, but you can change it by following these steps.
Note: If you do not complete each step with- in 8 seconds, the TAD exits setup. Start again from Step 1.
1.Hold down STOP until the TAD beeps once.
2.Press DIAL four times. 168 and SET CBT CODE appear. 1 flashes.
3.Repeatedly press :/8 to set the first digit, then press 9/;. The second digit flashes.
Note: If you make a mistake, repeatedly press 9/; until the desired digit flashes then
4.Repeat Step 3 to set the second and third digits.
5.Press DIAL then press STOP to return to the time display.
18 | TAD Operation | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|