Radio Shack 43-3577 owner manual On a Wall Plate or Wall

Page 9

ON A WALL PLATE OR WALL

To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base and the bracket.

Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch. Ô

1. Remove the bracket from the base and snap it into the notches on the bottom of the base.

2. Plug one end of the supplied modular cord (short for a wall plate, long for direct

wall mounting) into

the TEL LINE jack on the base’s back.

3.Plug the supplied AC adapter's barrel plug into the DC IN 9V jack.

4.Route the adapter

and modular cords through the bracket’s grooves.

5. For a wall plate, align the base and the bracket's keyhole slots with the wall plate studs and slide the base downward to secure it.

For direct wall mounting, align the base and the bracket's keyhole slots with the mounting screws and slide the base downward to secure it.

Ô NOTE Ô

If the base unit is mounted on the wall, always put the handset in the base with the CID display facing forward to make sure the handset does not fall out of the base.

Installation

9

Image 9

Contents Caller ID/Call Waiting ID MHz Cordless TelephoneContents Introduction FCC Statement InformationSurge Protection Save These Instructions Important Safety InstructionsInstallation Important Caller ID InformationSelecting a Location 9V DC and delivers at least On a Desk TOPOn a Wall Plate or Wall CONNECTING/CHARGING the Battery Pack Setting the Visual Ringer BrightnessInstallation Choosing the Dialing Mode Making and Receiving Calls OperationRedial Adjusting the Ringer and Earpiece VolumeTone Dialing SWITCH-OVER Traveling OUT-OF-RANGESelecting a Different Channel Voice Mail Waiting Indicator Setting Menu OptionsFlash and Call Waiting Setting the Language Changing the Auto Talk and CidcwEntering Your Area Code Storing Phone Numbers and Names Memory DialingMemory Dialing Steps for Entering Names and Special Characters Memory Dialing from Talk Mode Memory Dialing from Standby ModeIf you make a mistake while entering a name Making Calls with Memory DialingEditing a Stored Name AND/ or Phone Number Chain DialingPress SELECT. The confirmation screen appears Erasing a Stored Name and Phone NumberTesting Stored Emergency Numbers ONE-TOUCH Emergency DialStoring and Editing the Emergency Dial Deleting the Emergency Dial Making Calls with the Emergency DialCaller ID When the Telephone RingsViewing the Caller ID Message List Deleting Information from the Caller ID ListDeleting a Caller ID Message Long Distance Calls and Area Code Setting/Cancellation Using the Caller ID ListDeleting all Caller ID Names/Numbers Calling a Party from the Caller ID ListHeadset Installation Installing the BeltclipAdditional Information To attach the beltclipProblem Solution TroubleshootingCare Service and RepairRadioShack Corporation