Radio Shack 43-3577 Additional Information, Installing the Beltclip, To attach the beltclip

Page 29

Select the phone number to be stored from the Caller ID list by pressing RING/VOL/+ or RING/VOL/-.

2.Press MEM.

3.Press RING/VOL/+ or RING/VOL/- or enter a number (0 - 9) to select the memory location to be stored.

4.Press SELECT. Ô

You hear a confirmation tone, and the number is stored in memory. The display returns to the Caller ID list.

ADDITIONAL

INFORMATION

INSTALLING THE BELTCLIP

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

HEADSET INSTALLATION

You can connect an optional headset with a 3/32- inch (2.5-mm) plug. Contact RadioShack for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset. Then insert the headset’s plug into the jack.Ô

When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.

Additional Information

Ô NOTES Ô

Storing Caller ID Messages in Memory Dialing

If a message has already been stored in the selected memory number location, a confirmation screen is displayed.

Press RING/VOL/+ to select ¨Yes¨. Press SELECT to overwrite. The display returns to the Caller ID list.

Headset Installation

•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.

•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Caller ID/Call Waiting ID MHz Cordless TelephoneContents Introduction FCC Statement InformationSurge Protection Save These Instructions Important Safety InstructionsSelecting a Location InstallationImportant Caller ID Information 9V DC and delivers at least On a Desk TOPOn a Wall Plate or Wall CONNECTING/CHARGING the Battery Pack Setting the Visual Ringer BrightnessInstallation Choosing the Dialing Mode Making and Receiving Calls OperationRedial Adjusting the Ringer and Earpiece VolumeSelecting a Different Channel Tone Dialing SWITCH-OVERTraveling OUT-OF-RANGE Flash and Call Waiting Voice Mail Waiting IndicatorSetting Menu Options Entering Your Area Code Setting the LanguageChanging the Auto Talk and Cidcw Storing Phone Numbers and Names Memory DialingMemory Dialing Steps for Entering Names and Special Characters Memory Dialing from Talk Mode Memory Dialing from Standby ModeIf you make a mistake while entering a name Making Calls with Memory DialingEditing a Stored Name AND/ or Phone Number Chain DialingPress SELECT. The confirmation screen appears Erasing a Stored Name and Phone NumberStoring and Editing the Emergency Dial Testing Stored Emergency NumbersONE-TOUCH Emergency Dial Deleting the Emergency Dial Making Calls with the Emergency DialCaller ID When the Telephone RingsDeleting a Caller ID Message Viewing the Caller ID Message ListDeleting Information from the Caller ID List Long Distance Calls and Area Code Setting/Cancellation Using the Caller ID ListDeleting all Caller ID Names/Numbers Calling a Party from the Caller ID ListHeadset Installation Installing the BeltclipAdditional Information To attach the beltclipProblem Solution TroubleshootingCare Service and RepairRadioShack Corporation
Top Page Image Contents