Allied Telesis AT-2701FXA/ST manual Installing a Network Adapter Card, Removing the PC Cover

Installing the Hardware

Installing a Network Adapter Card

The following instructions apply to installing an AT-2701 series adapter card in most systems. Refer to the manuals that were supplied with your system for details about performing these tasks on your particular system.

To install the network adapter card, perform the following procedure:

1.Review the “Pre-Installation Checklist” on page 25 and “Reviewing Safety Precautions” on page 23.

Before installing the adapter card, ensure the system power is OFF and unplugged from the power outlet, and that proper electrical grounding procedures have been followed.

Warning

High voltage inside the system presents a safety hazard. Make sure the power is off before removing the cover.

2.Remove the system cover and select any empty PCI slot. See Figure 8.

If you do not know how to identify a PCI slot, refer to your system documentation.

Figure 8. Removing the PC Cover

28