Radio Shack TAD-1024 owner manual Screening Calls, Playing Messages

Page 12

43-784.fm Page 12 Monday, August 16, 1999 7:47 AM

SCREENING CALLS

To screen calls, let the TAD answer them, then listen to the caller’s message through the TAD’s speaker. If you de- cide to answer the call, pick up any phone on the same phone line as the TAD. The TAD stops recording and re- sets to answer the next call.

Note: If you pick up the phone just as the TAD answers, the TAD might not stop playing the outgoing message. If this happens, press on the phone or STOP/ TIME SET on the TAD.

If you do not want to take the call, do not pick up the phone, and let the TAD finish recording the caller’s message.

To adjust the volume, rotate VOLUME on the side of the TAD.

PLAYING MESSAGES

The display shows the total number of messages. If there are new messages, the power indicator also flashes until all new messages have been played.

To play all the messages (old and new), press PLAY. The TAD announces the number of messages recorded, each

12

message number and the day and time the message was recorded, and then plays the message.

To play only new messages, hold down PLAY for 2 seconds. (If there are no new messages stored, the TAD says, “You have no new messages.”)

To adjust the volume, rotate VOLUME on the side of the TAD.

After all messages play, the TAD says, “End of message(s)” and saves all the messages.

To replay a message while you are lis- tening to it, press MEMO/REPEAT. The current message starts again from the beginning.

Image 12
Contents TAD-1024 Features Fm Page 3 Monday, August 16, 1999 747 AM Read this Before Installation FCC StatementContents Installation Connecting PowerSelecting a Location Installing Backup Battery Setting the DAY Time PreparationRecording the Outgoing Messages Setting the Number of Rings Setting the TAD to Answer Calls Basic OperationRecording Incoming Messages Screening Calls Playing MessagesDeleting Messages Recording a Memo Recording a ConversationUsing Call BREAK- Through Changing the CBT CodeChanging the Remote Operation Security Code Remote Operation Remote ANSWER-ONUsing Remote Commands PressTroubleshooting Resetting the TADProblem Remedy Care and Maintenance FCC Wants YOU to Know LightningFm Page 22 Monday, August 16, 1999 747 AM Fm Page 23 Monday, August 16, 1999 747 AM Limited One-Year Warranty