Radio Shack TAD-1024 owner manual Changing the Remote Operation Security Code

Page 16

43-784.fm Page 16 Monday, August 16, 1999 7:47 AM

CHANGING THE REMOTE OPERATION SECURITY CODE

The remote operation security code is preset to 784, but you can change it by following these steps.

Note: Be sure to set each digit within 8 seconds. Otherwise, you must start over from Step 1.

1.Hold down CODE/SKIP until the TAD beeps once. Co appears.

2.Press CODE/SKIP again. Sc (securi- ty code) and the digits of the current code appear in sequence, then the first digit reappears.

For example, when the security code is 784, the display shows Sc (security code), 7, –8, 4, then 7 reappears.

3.Repeatedly press SKIP/CODE or MEMO/REPEAT to set the first digit, then press ANSWER. The second digit appears.

16

Note: If you enter an incorrect digit, press STOP/TIME SET, then repeat the procedure.

4.Press SKIP/CODE or MEMO/REPEAT to set the second digit, then press ANSWER. The third digit appears.

5.Press SKIP/CODE or MEMO/REPEAT to set the third digit, then press AN- SWER. The TAD sounds a long beep.

To check the remote operation security code at any time, follow Steps 1 and 2, then press STOP/TIME SET to exit.

Image 16
Contents TAD-1024 Features Fm Page 3 Monday, August 16, 1999 747 AM Read this Before Installation FCC StatementContents Connecting Power InstallationSelecting a Location Installing Backup Battery Setting the DAY Time PreparationRecording the Outgoing Messages Setting the Number of Rings Basic Operation Setting the TAD to Answer CallsRecording Incoming Messages Screening Calls Playing MessagesDeleting Messages Recording a Memo Recording a ConversationUsing Call BREAK- Through Changing the CBT CodeChanging the Remote Operation Security Code Remote Operation Remote ANSWER-ONUsing Remote Commands PressResetting the TAD TroubleshootingProblem Remedy Care and Maintenance FCC Wants YOU to Know LightningFm Page 22 Monday, August 16, 1999 747 AM Fm Page 23 Monday, August 16, 1999 747 AM Limited One-Year Warranty