Memory Dialing
±"016'"±"
•An error tone sounds and the phone exits the storing process if you wait more than 30 seconds between key presses.
•If the phone sounds five quick beeps, you have made an entry error and the number was not stored.
•Each tone or pause entry uses one digit of memory.
2.Press INTERCOM or 8/INTCM again to transfer the call when the person at the base or handset answers.
To start a
/'/14;"&+#.+0)
You can store up to 30 numbers in the handset’s memory and another 10 in the base’s memory, then dial a stored number by pressing a memory location number. You can also store a name with each number in the handset's memory. Each stored number can be up to 20 digits long, and each name can be up to 13 characters.
You cannot dial a number stored in one memory location (the base or the handset) using the keypad on the other.
5614+0)"#"07/$'4"+0"/'/14;
+P"VJG"*CPFUGV
1.Lift the handset.
2.Hold down MEM until C[cehoýIjeh[ and a list of memory location numbers (and names, if any) appears.
3.Select an empty memory location (or one you want to replace) by entering the location number
Precede a
4.Press SELECT/VOLUME. Ijeh[ýDWc[ appears. If you do not want to enter a name, skip to Step 6.
5.To enter a name, use the number keys. Refer to the letters on the number keys to select the desired letter. Press the key once for the first letter in upper case, press twice for the second letter in upper case, and so on. To enter the lower case letter, press four times (or five times) to display the first letter in lower case, five or six times for the second letter, and so on.
For example, to enter John: press 5 once; upper case @ appears. Then press 6 six times; lower case e appears. Press 4 five times; lower case ^ appears. Finally, press 6 five times; lower case d appears.
18