Radio Shack 43-683 2766+0#%#..10*1, 59+6%*+0$6906* *#0&56#0& 52#-42*10, Putting a Call On Hold

CALL ID/HOLD

Putting a Call On Hold

±"016'"±"

Putting a Call On Hold

Pressing HOLD (or CALL ID/ HOLD) again while a call is on hold does not release the hold. Press the line button that is on hold.

Using Both the Handset and Speakerphone

If you hear a high-pitched noise from the base’s speaker, the handset and the base are too close together.

2766+0)"#"%#.."10"*1.&

To put a call on hold, press HOLD (CALL ID/HOLD on the handset). The indicator for that line lights red on the base, and the handset display shows >ebZýabove the line number. While a call is on hold, you can temporarily place the handset on the base or use the other phone line without disconnecting the current call.±

To release a line from hold and continue your conversation, press that line’s button on the handset or base. You can also release a call from hold by lifting the handset if the handset is on the base, or picking up an extension phone.

You can alternate between the two lines by pressing HOLD, then the button for the desired line.

59+6%*+0)"$'69''0"6*'" *#0&5'6"#0&" 52'#-'42*10'

To switch to the speakerphone while you are using the

handset, presson the handset, then press the in-use line's button (LINE 1 or LINE 2) on the base.

To switch to the handset while you are using the speakerphone, just lift the handset off the base. Or, if the handset is off the base, press HOLD on the base, then press the in-use line's button (LINE 1 or LINE 2) on the handset.

75+0)"$16*"6*'"*#0&5'6" #0&"52'#-'42*10'

To use the handset to join a call at the base, or to use the base to join a conversation at the handset, press the line button for the line that is in use. You hear a busy tone.

Before the tone ends, press the line button again.

During the call, one party can hang up and the call can continue. To end the call, you must hang up both the base and handset.±

To talk with two parties using both lines, see “4-Way Conferencing” on Page 16.

14