Entering a Pause, Dialing a Memory Number

43-685.fm Page 26 Thursday, July 8, 1999 7:50 AM

To clear a stored number, simply store a new number in its place. Or, press MEM twice. Then press the memory location number (0–9) you want to clear. A tone sounds.

Use the supplied memory directory sticker to record your stored numbers. Peel the backing from the sticker and at- tach it to the base.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to connect.

To enter a 2-second pause, press PAUSE (INTCM/PAUSE on the handset). For a longer pause, press it additional times.

Reviewing Memory Numbers (Handset Only)

To review your memory numbers, press MEMORY. The list of the first three mem- ory location numbers (01–03) appears with the name stored with each number (or <Memory nn> if you did not store a name). If necessary, scroll through the list by repeatedly pressing or , or by entering the two-digit location number.

To view the stored phone numbers, press . An arrow to the right of the number means it is longer than 14 digits.

Press again to see the rest of the number. Repeatedly press to return to the name display.

To exit the memory number list, press

HOLD/CANCEL.

To see a stored name and phone num- ber at the same time, press SELECT when the cursor is by a memory location number. To exit this display without stor- ing any changes, hold down CONF/DE- LETE until the display clears.

Dialing a Memory Number

To dial a number stored in the handset’s memory, lift the handset from the base and press MEMORY. The list of the first three memory location numbers ap- pears. Choose a memory location (01–

30)by pressing number keys or by re- peatedly pressing or , then pressing LINE 1 or LINE 2. The ET-685 automati- cally dials out the number.