Radio Shack ET-685 owner manual Fm Page 32 Thursday, July 8, 1999 750 AM

Page 32

43-685.fm Page 32 Thursday, July 8, 1999 7:50 AM

Problem

Suggestion

 

 

 

 

Handset does not ring or receive a

Lift the base’s antenna to a vertical position.

page.

 

Move the handset closer to the base.

 

 

 

 

Move the handset and base away from other electri-

 

cal devices.

 

 

 

Recharge the battery pack.

 

 

You have an incoming call, but do

Let the phone ring twice before you answer so the

not receive Caller ID information.

system has time to record the Caller ID information.

 

 

 

Check that the system has been correctly and

 

securely connected.

 

 

 

Call your phone company to verify that your Caller ID

 

service is active.

 

 

If the base loses power while the handset is off of it, the security access-protection code might change. Restore power to the base, then place the handset back on the base and leave it there for a few seconds.

If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.

32

Image 32
Contents Line 900 MHz Spread Spectrum Cordless Speakerphone Features Security Access-Protection Code FCC Statement Read this Before InstallationImportant Caller ID Information Fm Page 5 Thursday, July 8, 1999 750 AM Contents Replacing the Battery Pack FCC Wants You to Know Installation Connecting to the Phone LinesMounting the Phone On a Desk TopFm Page 9 Thursday, July 8, 1999 750 AM On a Wall Plate or a Wall Fm Page 11 Thursday, July 8, 1999 750 AM Connecting and Charging the Battery Pack Setting the Dialing Mode Adjusting the Ringer Setting Auto TalkOn the Handset On the BaseTurning Caller ID/ Call Waiting ON/OFF Storing Your Area CodeFm Page 16 Thursday, July 8, 1999 750 AM Using the Handset Setting the Handset VolumeBasic Operation Making a CallUsing Speakerphone Using HoldAdjusting the Speakerphone Volume Using MuteUsing Both Handset Speakerphone Switching Between the Handset and SpeakerphoneMaking a Conference Call Way ConferencingDelete Using Flash Using RedialUsing Tone Services on a Pulse Line Using a Headset Handset Memory OperationStoring a Number in Memory Editing or Deleting a Number in the Handset’s Memory BaseDialing a Memory Number Entering a PauseReviewing Memory Numbers Handset Only Chain-Dialing Service Numbers Testing Stored Emergency NumbersCaller ID Operation Handset only Reviewing Caller ID Records Caller ID Messages Storing a Caller ID Record to MemoryDeleting Caller ID Records Troubleshooting Problem SuggestionFm Page 32 Thursday, July 8, 1999 750 AM Care and Maintenance Replacing Battery Pack FCC Wants YOU to KnowLightning RadioShack