SETTING THE PULSE/ TONE SWITCH
Set PULSE/TONE for the type of service you have. If you are not sure which type you have, do this test.
1.Set PULSE/TONE to TONE.
PULSE TONE
2.Press TALK on the handset and listen for a dial tone. The indicator above TALK turns on.
TALK |
| PRIVACY / LOW BATT |
TALK | CH | OFF |
1 | ABC 2 | DEF 3 |
3.Press any number other than 0.
If the dial tone stops, you have touch tone service. Leave PULSE/ TONE set to TONE.
If the tone continues, you have pulse service. Set PULSE/TONE to
PULSE.
4.To hang up, either place the hand- set on the base or press OFF on the handset.
ADJUSTING THE
RINGER
Checking/Setting the Ringer Type
The
1.To check or change the ringer type, follow these steps.
1.Press PROG. The indicator above TALK flashes.
|
| PRIVACY / LOW BATT |
|
TALK | CH | OFF |
|
1 | ABC 2 | DEF 3 |
|
GHI 4 | JKL 5 | MNO 6 |
|
PRS 7 | TUV 8 | WXY 9 |
|
TONE | OPER0 | # | PROG |
HOLD | FLASH |
|
|
MEM | PROG | REDIAL |
|
2.Within 30 seconds, press #, then press
Notes:
•To hear the currently selected ringer type, press 0 anytime after you press # during this step.
•If the indicator above TALK turns off before you make your selection, press PROG again then repeat this step.
3.When you hear the ringer type you want to use, press # to select it. The indicator turns off.
13