Radio Shack 43-3549 Additional Information, To attach the beltclip, To remove the beltclip

Page 32

Additional Information

Ô NOTES Ô

•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.

•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.

ADDITIONAL

INFORMATION

INSTALLING THE BELTCLIP

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

HEADSET INSTALLATION

You can connect an optional headset with a 3/32-inch (2.5-mm) plug. Contact RadioShack for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset. Then insert the headset’s plug into the jack.Ô

When you ﬁnish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.

32

Image 32

Contents GHz Cordless Telephone Introduction IntroductionInformation FCC StatementSurge Protection Important Safety Instructions Important Caller ID Information Installation Selecting a LocationOn a Wall Plate or Wall On a Desk TOPCONNECTING/CHARGING the Battery Pack Replace the cover OWARNING o Operation Making and Receiving CallsHandset Ringer Tone and Volume Earpiece VolumeAdjusting the Handset Ringer and Earpiece Volume Temporarily Mute RingerSelecting a Different Channel Tone Dialing SWITCH-OVERTraveling OUT-OF-RANGE Voice Mail Waiting Indicator Voice Mail Waiting IndicatorFlash and Call Waiting Flash and Call WaitingEntering Your Area Code Setting Menu OptionsChanging the Auto Talk Choosing the Dialing Mode Setting the Language Setting the LanguageMemory Dialing Storing Phone Numbers and NamesPress MEM or Select Steps for Entering Names and Special Characters If you make a mistake while entering a name To delete all characters, press and hold DELETE/CHMemory Dialing from Standby Mode Memory Dialing from Talk ModeMaking Calls with Memory Dialing Chain DialingEditing a Stored Name AND/OR Phone Number Erasing a Stored Name and Phone Number Use the number key, /TONE/, #Testing Stored Emergency Numbers ONE-TOUCH Speed DialStoring and Editing the Speed Dial Making Calls with the Speed DialDeleting the Speed Dial Storing and Editing the Speed DialWhen the Telephone Rings Caller IDViewing the Caller ID Message List You may receive any one of the following messagesDeleting a Caller ID Message Deleting all Caller ID Names/ NumbersDeleting Information from the Caller ID List Deleting a Caller ID MessageLong Distance Calls and Area Code Setting/Cancellation Using the Caller ID ListCalling a Party from the Caller ID List Storing Caller ID Messages in Memory DialingPress MEM Installing the Beltclip Headset InstallationAdditional Information To attach the beltclipTroubleshooting Problem SolutionService and Repair CarePage RadioShack Corporation