Radio Shack 43-3549 owner manual On a Wall Plate or Wall, On a Desk TOP

Page 8

ON A DESK TOP

1.Plug one end of the supplied long modular cord into the TEL LINE jack on the bottom of the base.

TEL

LINE DC IN 9V

Installation

∀ CAUTION ∀

You must use

!a Class 2 power source that supplies

9V DC and delivers at least 350 mA. Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.

2. Insert the supplied

AC adapter’s barrel plug into the DC IN 9V jack on the bottom of the

base and route the adapter’s cord through the strain relief slot on the base.∀

3.Plug the other end of the modular cord into a modular phone line jack.

4.Plug the adapter into a standard AC outlet.

ON A WALL PLATE OR WALL

To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base.

Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.

1.Plug one end of the supplied modular cord (short for a wall plate, long for direct wall mounting) into the TEL LINE jack on the base’s back.

2.Plug the supplied AC adapter's barrel plug into the DC IN 9V jack.

3.Route the adapter and modular cords through the base’s grooves.

8

Image 8

Contents GHz Cordless Telephone Introduction IntroductionInformation FCC StatementSurge Protection Important Safety Instructions Important Caller ID Information Installation Selecting a LocationOn a Wall Plate or Wall On a Desk TOPCONNECTING/CHARGING the Battery Pack Replace the cover OWARNING o Operation Making and Receiving CallsHandset Ringer Tone and Volume Earpiece VolumeAdjusting the Handset Ringer and Earpiece Volume Temporarily Mute RingerSelecting a Different Channel Tone Dialing SWITCH-OVERTraveling OUT-OF-RANGE Voice Mail Waiting Indicator Voice Mail Waiting IndicatorFlash and Call Waiting Flash and Call WaitingEntering Your Area Code Setting Menu OptionsChanging the Auto Talk Choosing the Dialing Mode Setting the Language Setting the LanguageMemory Dialing Storing Phone Numbers and NamesPress MEM or Select Steps for Entering Names and Special Characters If you make a mistake while entering a name To delete all characters, press and hold DELETE/CHMemory Dialing from Standby Mode Memory Dialing from Talk ModeMaking Calls with Memory Dialing Chain DialingEditing a Stored Name AND/OR Phone Number Erasing a Stored Name and Phone Number Use the number key, /TONE/, #Testing Stored Emergency Numbers ONE-TOUCH Speed DialStoring and Editing the Speed Dial Making Calls with the Speed DialDeleting the Speed Dial Storing and Editing the Speed DialWhen the Telephone Rings Caller IDViewing the Caller ID Message List You may receive any one of the following messagesDeleting a Caller ID Message Deleting all Caller ID Names/ NumbersDeleting Information from the Caller ID List Deleting a Caller ID MessageLong Distance Calls and Area Code Setting/Cancellation Using the Caller ID ListCalling a Party from the Caller ID List Storing Caller ID Messages in Memory DialingPress MEM Installing the Beltclip Headset InstallationAdditional Information To attach the beltclipTroubleshooting Problem SolutionService and Repair CarePage RadioShack Corporation