Radio Shack 43-3549 owner manual Choosing the Dialing Mode

Page 17

1.When the phone is in the standby mode, press and hold CID/MENU. The Caller ID setting screen appears.

2.Press VOL/RING key twice to select ¨Area Code¨.

3.Press SELECT. Ô

4.Use the number keys (0 - 9), or DELETE/CH to enter the three-digit area code.

5.Press SELECT. A conﬁrmation tone sounds and the displayed area code is entered.

6.Press END or return the handset to the base unit to complete the setting. The handset returns to the standby mode.

Choosing the Dialing Mode

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems still use pulse dialing such as in rural areas.

The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

1.When the phone is in the standby mode, press and hold CID/MENU.

2.Press VOL/RING key three times to select ¨Dial¨.

3.Press SELECT to toggle between

¨Tone¨ and ¨Pulse¨ for each setting.

4.Press END or return the handset to the base unit to complete the setting. The handset returns to the standby mode.

Ô NOTE Ô

When the area code has already been stored in memory, the stored area code will be displayed. To change it, use the DELETE/CH and number keys to enter the new area code. Then press SELECT. A confirmation tone sounds. To complete the setting, press END or return the handset to the base unit.

Operation

17

Image 17

Contents GHz Cordless Telephone Introduction IntroductionFCC Statement InformationSurge Protection Important Safety Instructions Important Caller ID Information Selecting a Location InstallationOn a Desk TOP On a Wall Plate or WallCONNECTING/CHARGING the Battery Pack Replace the cover OWARNING o Making and Receiving Calls OperationEarpiece Volume Handset Ringer Tone and VolumeAdjusting the Handset Ringer and Earpiece Volume Temporarily Mute RingerSelecting a Different Channel Tone Dialing SWITCH-OVERTraveling OUT-OF-RANGE Voice Mail Waiting Indicator Voice Mail Waiting IndicatorFlash and Call Waiting Flash and Call WaitingEntering Your Area Code Setting Menu OptionsChanging the Auto Talk Choosing the Dialing Mode Setting the Language Setting the LanguageMemory Dialing Storing Phone Numbers and NamesPress MEM or Select Steps for Entering Names and Special Characters To delete all characters, press and hold DELETE/CH If you make a mistake while entering a nameMemory Dialing from Talk Mode Memory Dialing from Standby ModeMaking Calls with Memory Dialing Chain DialingEditing a Stored Name AND/OR Phone Number Use the number key, /TONE/, # Erasing a Stored Name and Phone NumberONE-TOUCH Speed Dial Testing Stored Emergency NumbersMaking Calls with the Speed Dial Storing and Editing the Speed DialDeleting the Speed Dial Storing and Editing the Speed DialCaller ID When the Telephone RingsYou may receive any one of the following messages Viewing the Caller ID Message ListDeleting all Caller ID Names/ Numbers Deleting a Caller ID MessageDeleting Information from the Caller ID List Deleting a Caller ID MessageUsing the Caller ID List Long Distance Calls and Area Code Setting/CancellationCalling a Party from the Caller ID List Storing Caller ID Messages in Memory DialingPress MEM Headset Installation Installing the BeltclipAdditional Information To attach the beltclipProblem Solution TroubleshootingCare Service and RepairPage RadioShack Corporation