Radio Shack 12-259 owner manual Programming the WEATHERADIO, Attaching the Belt Clip

Programming the Weatheradio‚

Ô NOTE Ô

•The weatheradio does not receive alert signals during programming.

•If you press MENU or do not press a key for 45 seconds while programming, the weatheradio saves all valid entries you made and exits programming mode.

ATTACHING THE BELT CLIP

Insert the clip into the hole at the back of the weatheradio until it clicks. To remove the belt clip, press the button on the tip of the clip and pull it out.

ATTACHING THE WRIST STRAP (NOT SUPPLIED)

Slide the wrist strap’s small loop under the bar at the back of the weatheradio. Then pull the strap’s large loop through the small loop and fasten it.

PROGRAMMING THE WEATHERADIO

Your Weatheradio is pre-programmed with seven NOAA broadcast frequencies (channels 1-7). Depending on your location, you might need to select a different channel.

Your Weatheradio is preset to receive any weather alert broadcast within about a 50 mile radius. The first time you use your Weatheradio, it scans for the strongest channel and receives all SAME alert signals broadcast within a 50 mile radius of its location. Ô

6