On a Wall, Illus. showing screw positions on

43-764.fm Page 10 Friday, August 13, 1999 2:43 PM

On a Wall

You need two flat-head wood screws (not supplied) with heads that fit into the keyhole slots on the bottom of the TAD.

1.Drill two holes 315/16 inches (100

mm)apart. Then thread a screw into each hole letting the heads extend about 3/16 of an inch (5 mm) from the wall.

Illus. showing screw positions on the

2.Plug one end of the supplied long modular cord into the TO LINE jack on the back of the base.

Illus of TO LINE jack and end of modular cord about to be inserted into jack. Oth- er connections are not yet made.

3.Route the cord into the groove on the phone’s base.

Illus. showing routing of modular cord.

4.Plug one end of the supplied coiled cord into the jack on the bottom of the base and route the cord into the groove beside the jack.

Illus. showing routing of coiled cord before it is plugged into the handset.

5.Insert the supplied AC adapter’s barrel plug into the AC 9V 440mA jack on the back of the base.

Illus. of AC 9V 440mA jack. Showing barrel plug about to be inserted into jack and modular cord already con- nected.

6.With the power cord moved to the right of the two tabs and the modu- lar cord hanging straight down from the groove, align the two screws with the TAD’s keyhole slots and slide the TAD downward to secure it.

Illus. showing bottom of base, keyhole slots, screws.

Also, show power cord and modular cord hanging down.