PREPARATION
SETTING THE DIALING MODE
Set TONE/PULSE on the handset for the type of service you have. If you are not sure which type you have, do this test.
Illus. of TONE/PULSE switch.
Follow these steps to set the current day and time.
Note: If you do not complete each step within 8 seconds, the TAD beeps three times and stops setting the day and time. Start again at Step 1.
1.Use a straightened paper clip to hold down CLOCK (located on the TAD’s right side) until the
Illus. showing CLOCK switch.
1.Set TONE/PULSE to TONE.
2.Lift the handset and listen for a dial tone.
3.Press any number other than 0.
Notes: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.
If the dial tone stops, you have
If the dial tone continues, you have pulse service. Set TONE/PULSE to
PULSE.
SETTING THE DAY AND TIME
The answering system records the day and time of each incoming message.
Note: If necessary, adjust VOLUME.
2.To change the day of the week, repeatedly press OGM/REPEAT to move back or PLAY/SKIP to move forward to the current day of the week.
Illus. showing OGM/REPEAT and PLAY/SKIP.
12