Radio Shack 43-3808 owner manual Deleting Messages, To replay the messages, press PLAY/PAUSE/MIN

Page 17

The system announces the day and time the message was re- corded. After you play all the new messages, the display shows the total number of recorded messages, and the system auto- matically saves the messages and resets to answer calls.

Note: If there are no messages, the system sounds two tones.

To pause while listening to message, press PLAY/PAUSE/MIN. P appears on the display. The playback resumes when you press PLAY/PAUSE/MIN again, or the system returns to answer-ready mode after 7 seconds if you do not press PLAY/PAUSE/MIN again.

To replay the messages, press PLAY/PAUSE/MIN.

During message playback, you can repeat the current message by pressing REPEAT/ANNC/DAY, repeat a previous message by holding down REPEAT/ANNC/DAY for over 1 second, or skip for- ward to the next message by pressing SKIP/TIME SET/CHECK.

To stop message playback at any time, press ON/OFF/STOP.

Note: Each message will be treated as a new message until you play back the entire message.

DELETING MESSAGES

You can delete messages individually during playback, or all at once after playback.

To delete a particular incoming message, memo, or two-way phone conversation (after listening to it), press DELETE during playback.

Operation

17

Image 17
Contents Digital Answering System Read This Before Installation FCC Wants YOU to Know FCC StatementRead This Before Installation Contents Features Preparation Installing the Backup BatteryConnecting AC Power Connecting the System to a Phone Line Turning the System ON/OFF Adjusting the VolumeSetting the DAY and Time Setting the Number of Rings Recording the Outgoing Message Setting the Incoming Message LengthOperation Setting the System to Answer CallsUsing Announce-Only Screening Calls Recording a Memo Playing Incoming MESSAGES/MEMOS/ TWO-WAY Phone Conversations Recording a TWO-WAY Phone ConversationTo replay the messages, press PLAY/PAUSE/MIN Deleting MessagesOperating the System from a Remote Location Remote OperationSecurity Code Lightning Remote CommandsLimited One-Year Warranty