GE 800-EFM manual Additional Information FCC Information

Page 42

Additional Information

FCC Information

This equipment complies with Part 68 of the FCC rules. On the base of this equipment is a label that contains, among other information, the FCC registration number and ringer equivalence num- ber (REN) for this equipment. If requested, this information must be provided to the telephone company.

The FCC requires that you connect your feature module to the telephone network through a mod- ular telephone outlet or jack, which must comply with FCC part 68 rules.The modular telephone outlet or jack to which your feature module must be connected is a USOC RJ11C or RJ14C.

The REN is used to determine the quantity of devices which may be connected to the telephone line. The REN for your feature module is 0.1. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5). To be certain of the number of devices that may be con- nected to the line, as determined by the total RENs, contact the telephone company to determine the maximum REN for the calling area.

If the terminal equipment feature module causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify you as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens, the telephone company will pro- vide advance notice in order for you to make the necessary modifications in order to maintain unin- terrupted service.

If trouble is experienced with your feature module, please contact TMC Corporation at 1-800-TMC-1638for repair and/or warranty information. If the trouble is causing harm to the telephone network, the telephone company may request you remove the equipment from the network until the problem is resolved. Do not attempt to repair or modify this equipment. Please contact TMC Corporation for information on obtaining service for this product.

This equipment cannot be used on public coin service provided by the telephone company. Connection to Party Line Service is subject to state tariffs. (Contact the state public utility com- mission, public service commission or corporation commission for information.)

38

Image 42
Contents Please read before using feature module Model 800-EFMUser’s Guide Important Safety Instructions Getting StartedPacking List Before you beginTable of Contents Additional Information Reference Drawing Installing Your External Paging Adapter Installing Your External Paging AdapterInstalling Your External Paging Adapter Connect Line Cord Connect Line CordSet Switches Set SwitchConnect Power Cord to Wall Outlet Installing Your External Paging Adapter Connect Power CordConnect Power Cord to Module Make Sure that Status Indicator lamp is BlinkingLocate 8-wire Cord Connect Cord to Feature ModuleConnect other end of Cord to Wiring Block Install Amplifier and Speaker Connect Wiring Block to Input of AmplifierListen to Speaker Volume Adjust the Volume of the SpeakerIf Necessary, use the Feature Module’s Volume Control Knob Using Your External Paging Adapter Using Your External Paging AdapterTo make an All Using Your External Paging Adapter Important Points to Note Using Your External Paging Adapter Troubleshooting Guide Installing Your Door Intercom Adapter Installing Your Door Intercom AdapterInstalling Your Door Intercom Adapter Connect Line Cord Set Switches 5-6 Optional Installing Your Door Intercom Adapter Connect Power Cord Wiring Block Install Door Speaker Connect Speaker Wires to Wiring BlockInstall Doorbell Connect Doorbell Wires to Wiring BlockInstall Magnetic Door Strike Using Your Door Intercom Adapter Using Your Door Intercom AdapterTo answer a door speaker over the intercom Using Your Door Intercom Adapter Important Points to Note Using Your Door Intercom Adapter Troubleshooting Guide Installing Your Music on Hold Adapter Installing Your Music on Hold AdapterInstalling Your Music on Hold Adapter Connect Line Cords Connect First Line CordConnect Second Line Cord Set Switches Installing Your Music on Hold Adapter Connect Power Cord Installing Your Music on Hold Adapter Connect Music Source Connect Audio Cable to ModuleConnect Audio Cable to Music Source Using Your Music on Hold Adapter Using Your Music on Hold AdapterPage Page Adjust the Volume of the Music Source Using Your Music on Hold Adapter Adjusting Music VolumeListen to Music on Hold Volume If Necessary, use the Module’s Volume Control KnobUsing Your Music on Hold Adapter Usage Notes Using Your Music on Hold Adapter Troubleshooting Guide That the status indicator lamp is blinking. If itAdditional Information Warranty Information TWO-YEAR Limited WarrantyAdditional Information FCC Information Additional Information FCC Information TMC Corporation Route 130, Unit 117 Cranbury, NJ 08512