Multi-Tech Systems iCell GPRS (MTSMC-G2-IP manual Set Commands, AT Command Mode, Turn Echo ON/OFF

Part 1 – AT Commands for All Universal IP Devices Chapter 1 – General AT Commands for All Universal IP Devices

Chapter 1 – General AT Commands

for All Universal IP Devices

Set Commands

AT – Command Mode

Description: If the modem responds OK to an AT command, the modem is likely in command mode. Many commands will respond with ERROR when the modem is connected to the network.

E – Turn Echo ON/OFF

Description: Use this command to turn ON/OFF echoing command at the serial terminal.

Syntax: ATE[<setting>]

Values: 0 – turn echo off. 1 – turns echo on.

I – Identification

Description: Displays identification parameters.

Syntax: ATI[<value>]

Responses: For MT100SEM: "1.00 to 1.00g"

For MT810SWM-IP: "1.xx" (Note: "xx" is the number.)

OK

Values:	3	– Identifies the firmware version.
		Example:	Version:MT810swm Release V1.0 (12-August-09)
	5		OK
		– Identifies the country.

Example: "B5" (MT100SEM example)

V – Terse or Verbose

Description:	Sets terse or verbose responses.
Syntax:	ATV[<value>]
	ATV? Displays the current V setting or use AT#VALL to view all settings.
Values:	0	– Sets terse mode (ATV also sets terse mode)
	1	– Sets verbose mode
Default:	ATV1

Universal IP AT Commands Reference Guide (Document S000457K) 10