Talkswitch TS-100 instruction manual Redial Button, Pause Button, Hold Button, HOLD/FLASH Button

Page 12

Telephone Features

REDIAL BUTTON

1.If the number you dialed is busy, or you want to call the last number dialed again, lift the handset, or press and release the hookswitch for a new dial tone.

2.Press REDIAL. The number will appear on the display window.

3.The last number called (31 digits maximum) will automatically be redialed.

Note: If you use a hunt group such as ‘9’ to get external dialtone first, you may encounter problems with dialing out since it takes time for TalkSwitch to switch from internal dialtone to external dialtone so the 1st digit of the phone number may be missed by the phone company.

PAUSE BUTTON

The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This is particularly useful if you are connected to a PABX system where you must dial an access code (usually the number 9) to obtain an outside line.

1.Press the PAUSE button once and release at any point in the dialing sequence where a pause is desired.

2.The PAUSE button can be pressed more than once to create a longer pause.

HOLD BUTTON

1.To place a call on hold using TalkSwitch, be sure to use the HOLD/FLASH button located at the top right NOT the HOLD button located at the bottom left. The HOLD button located at the bottom of the phone should only be used when the phone is not connected to a phone system.

2.To retrieve a caller simply press HOLD/FLASH + ‘7’. If you hung up the phone after putting a call on hold, the phone will ring back within 60 seconds. Answer the phone and you will be connected to the caller.

HOLD/FLASH BUTTON

This telephone provides a line break signal for putting callers on hold or to transfer calls.

1.To place a call on hold using TalkSwitch, be sure to use the HOLD/FLASH button located at the top right not the HOLD button located at the bottom left. The HOLD button located at the bottom of the phone should only be used when the phone is not connected to a phone system.

2.To retrieve a caller simply press HOLD/FLASH + ‘7’. If you hung up the phone after putting a call on hold, the phone will ring back within 60 seconds. Answer the phone and you will be connected to the caller.

Flash can also be used when storing numbers in memory locations when Direct Line Access has been enabled on Local Extensions connected to TalkSwitch.

TS-100 Owner’s Manual

6

Page 11 Page 13
Image 12
Page 11 Page 13
Contents TalkSwitch TS-100 Multi-Feature Telephone Page Table of Contents Telephone Part Identification Telephone Display Identification Important Safety Instructions Installation Telephone Usage24/90V Message Waiting Lamp Wall Mount Instructions Telephone Usage Factory Presets SetupTelephone Features Pulse and Tone DialingReceiving a Phone Call Placing a Phone CallVolume Button Duration CounterMute Button Automatic MemoryRedial Button Pause ButtonHold Button HOLD/FLASH ButtonHeadset Compatible Data PortCall Waiting Display Using The Telephone With TalkSwitch Hang up your extension immediatelyUsing The Telephone With TalkSwitch Local ExtensionsOutside / 1 Local Caller Customizing the Telephone For Talkswitch Caller ID Features If Your Service is FSK Including TalkSwitchMessage Light Message WaitingCaller ID Features Receiving CallsReviewing Calls Deleting Calls Calling Back from the Caller ID ListOptions Button 785Message Error No Data SentPrivate Calls Unknown CallsTelephone Service Problems Maintenance InformationTelephone Repair Troubleshooting FCC Information Limited Warranty Carling Ave., Suite 510, Ottawa, ON, K1Z 8P9
Top Page Image Contents