Talkswitch TS-100 Telephone Features, Pulse and Tone Dialing, Receiving a Phone Call

Page 10

Telephone Features

PULSE AND TONE DIALING

1.If your telephone line accepts a touch-tone dialing, set the PULSE/TONE switch to the Tone position. In order for the phone to function properly with TalkSwitch, this switch must be set to Tone. If your telephone line requires a rotary (pulse) dialing, set the PULSE/TONE switch to the Pulse position.

Note: In order for the Caller ID callback to work (see Using the Caller ID Function), you must set the PULSE/TONE switch to the Tone position.

RECEIVING A PHONE CALL

1.Be sure the RINGER switch is set to the HI or LOW position.

2.When the phone rings and the caller’s information shows on the display window (refer to Using the Caller ID Function), lift the handset or press the SPEAKERPHONE button and begin your conversation.

3.Set the Ringer switch to the OFF position when you do not want to be interrupted by the phone ringing. Remember to set the ringer switch back to Hi or Low when you want to receive calls again.

PLACING A PHONE CALL

1.Lift the handset or press the SPEAKERPHONE button and wait for a dial tone.

2.Dial the telephone number you wish to call. The number will appear on the display window.

SPEAKERPHONE BUTTON

(AC Adaptor must be used to ensure proper function)

1.Receiving Incoming Calls

a.When the phone rings and the callers information shows on the display window (refer to Using the Caller ID Function), press and release the Speakerphone button and talk normally into the built-in microphone from a distance of 5-6 inches.

b.You can adjust the volume of the caller s voice by sliding the VOLUME CONTROL on the right side of the phone.

c.After the conversation has finished, press the SPEAKERPHONE button to hang up.

2.To Make A Call

a.Press and release the SPEAKERPHONE button.

b.When you hear a dial tone, dial the number or press the auto memory button just as you would on any other push-button telephone. The number will appear on the display window.

c.When your party answers, adjust the sound level of his or her voice by sliding the VOLUME CONTROL located on the right side of the phone.

d.After the conversation has finished, press SPEAKERPHONE to hang up.

TS-100 Owner’s Manual

4

Page 9 Page 11
Image 10
Page 9 Page 11
Contents TalkSwitch TS-100 Multi-Feature Telephone Page Table of Contents Telephone Part Identification Telephone Display Identification Important Safety Instructions Telephone Usage Installation24/90V Message Waiting Lamp Wall Mount Instructions Telephone UsageFactory Presets SetupReceiving a Phone Call Telephone FeaturesPulse and Tone Dialing Placing a Phone CallMute Button Volume ButtonDuration Counter Automatic MemoryHold Button Redial ButtonPause Button HOLD/FLASH ButtonData Port Headset CompatibleCall Waiting Display Using The Telephone With TalkSwitch Hang up your extension immediatelyLocal Extensions Using The Telephone With TalkSwitchOutside / 1 Local Caller Customizing the Telephone For Talkswitch Message Light Caller ID FeaturesIf Your Service is FSK Including TalkSwitch Message WaitingReceiving Calls Caller ID FeaturesReviewing Calls Deleting Calls Calling Back from the Caller ID ListOptions Button 785Private Calls Message ErrorNo Data Sent Unknown CallsMaintenance Information Telephone Service ProblemsTelephone Repair Troubleshooting FCC Information Limited Warranty Carling Ave., Suite 510, Ottawa, ON, K1Z 8P9
Top Page Image Contents