B. Broadcasting from Base to Handset
1.Broadcast to all handsets
a.Press Broadcast key on the base station to broadcast to all registered handsets.
b.After hearing
c.The Broadcast LED will light up.
d.Press the Broadcast key again and return to IDLE mode.
C. Broadcasting from Handset to Base
1.Broadcast to the base station
a.Enter the Base ID and then press “BROADCAST” key.
b.After hearing
c.The related base, within communication range of initiating handset, will receive the broadcast.
d.Press the END key to end the broadcasting.
Redial
1. Press REDIAL (Left) soft key.
11
PA paging from Base 1
SLIENT
11
PA paging to Ext. # 10
Silent soft key) to answer.
Notes:
1.You can press SILENT (Left) soft key if you choose to ignore the call. Unlike turning off the ringer (from the handset menu), the SILENT key operation is valid only for the current call.
2.If Caller ID service is available, the LCD will display the incoming call information. If the LCD shows “Private” or “Unknown”, the caller’s information may have been blocked by the caller or the originating phone company.
Receiving an Intercom Call
1.When an intercom call arrives, the ringer will ring or vibrate unless the ringer has been turned off. Press TALK to answer the intercom call.
2.If the handset is on the charger cradle (ringer will be temporarily switched to “Ring” if it has been set to “Vibrate”), lift the handset and start the conversation.
3.If the handset is not on the cradle, press any key (except END and the SILENT soft key) to answer.
Notes:
1. | The LCD displays the caller’s Handset ID. |
2. | You can press the SILENT if you choose to ignore the call. Unlike |
2.The LCD shows the last phone number dialed. To dial this number, press DIAL (Left) soft key.
3.Use Up or Down Arrow Key to scroll through the last 10 phone numbers dialed. Select and press DIAL key.
[Note] Intercom numbers (Handset ID) are not stored in the last 10 numbers dialed log.
turning off the ringer the SILENT key operation is valid only for the |
current call. |
Ending a Call
To end a telephone or intercom call, press END key or place handset into charging cradle.
Receiving a Telephone Call
1. | When an incoming call arrives, the ringer will ring or vibrate unless the |
| ringer has been turned off. |
2. | If the handset is on the charger cradle (ringer will be temporarily |
| switched to “Ring” if it has been set to “Vibrate”), lift the handset and |
Adjusting Receiver (Earpiece) Voice Volume
1.Voice volume can only be adjusted during a call.
2.There are 6 levels of volume selections. Default as volume 4. Use ¿andÀ scrolling key to adjust.
11
00:00:10
Volume:4
OPTION HOLD
start the conversation. |
3. If the handset is not on the cradle, press any key (except END, and the |
3. The new setting remains effective for all future calls until changed.
~25~ | ~26~ |