Memorex MSP-PH2400 Do not use the telephone to report a gas leak near the leak

Page 3

IMPORTANT SAFETY PRECAUTIONS (CONTINUED)

5.Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury and serious damage to the product.

6.Slots and openings in the cabinet and in the back or bottom are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat source. This product should not be placed in an enclosed environment unless proper ventilation is provided.

7.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on it.

8.Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.

9.Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid on the product.

10.To reduce the risk of electric shock, do not disassemble this product, but take it to a qualified serviceman when some service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect re-assembly can cause electric shock when the appliance is subsequently used.

11.Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power-supply cord or plug is damaged or frayed.

b.If liquid has been spilled into the product.

c.If the product has been exposed to rain or water.

d.If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e.If the product has been dropped or the cabinet has been damaged.

f.If the product exhibits a distinct change in performance.

12.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

13.Do not use the telephone to report a gas leak near the leak.

2

MSP-PH2400/09172C(ENGLISH)

3

12/16/01, 12:29 PM

Image 3
Contents Model MSP-PH2400 Risk of Electric Shock Do not Open Important Safety PrecautionsDo not use the telephone to report a gas leak near the leak Battery Precautions Important Safety Precautions Contents Handset Location of ControlsPlease Refer to the Following Diagram for Steps 4 Through Installation InstructionsInstallation of the Rechargeable Battery SET-UP Instructions Setting the RingerSetting the Language Setting the First Ring Mode Setting the Time Setting the Area Code Setting the LCD Contrast Setting the PBX Number Setting the PBX Mode Setting the Pause Time Setting the MSG Message Waiting Setting the Auto Answer Mode Setting the Private Ring Mode Setting the Unavailable Ring Mode Placing a Call Basic OperationReceiving a Call Ending a Call Using the Redial DEL/RE-PA ButtonMSG Waiting Voice Mail Messages OUT of Range WarningTONE/PULSE Switch Using the Base page Button Using the FlashChecking the Caller ID LOG Using the Tone Button Call WaitingDeleting NAMES/NUMBERS from the Caller ID LOG Deleting ONE NAME/NUMBER from the Caller ID LOGDialing a Number in the Caller ID Display Saving Caller ID Information to the Directory Adding a Directory EntryCharacter MAP Chart Entering a Name Using the KEY ButtonsDialing a Number from the Directory Rejecting Blocking Calls REJ Preferred Calls VIPEditing a Directory Entry Deleting ONE NAME/NUMBER from the Directory Symptom Solution Troubleshooting GuideCare and Maintenance MSP-PH2400/09172CENGLISH 12/16/01, 1230 PM Memcorp, Inc Weston, FL