Memorex MSP-PH2400 operating instructions Installation Instructions

Page 8

INSTALLATION INSTRUCTIONS

1.Carefully unpack and remove your unit from the box.

2.Make sure all the items have been included:

Base Unit	AC Adapter
Handset Unit	Telephone Cord
Rechargeable Ni-Cd Battery Pack	Belt Clip

3.Make sure the Rechargeable Battery is installed or install the Rechargeable Battery as described on the next page.

PLEASE REFER TO THE FOLLOWING DIAGRAM FOR STEPS 4 THROUGH 7:

4.Slide the T/P switch on the bottom of the Base unit to TONE or PULSE to match the service provided on your telephone line. If you are not sure of your service, please contact your telephone company. The factory preset position for this switch is TONE.

AC POWER

ADAPTER

TELEPHONE

LINE CORD

5.Connect the telephone line cord into a modular telephone jack.

6.Insert the small plug at the end of the AC adapter into the DC power jack

located at the rear of the base.

NOTE: Use only the AC adapter provided with your unit.

7.Plug the AC adapter into a standard 120V AC wall outlet.

7

MSP-PH2400/09172C(ENGLISH)

8

12/16/01, 12:29 PM

Image 8

Contents Model MSP-PH2400 Important Safety Precautions Risk of Electric Shock Do not OpenDo not use the telephone to report a gas leak near the leak Battery Precautions Important Safety Precautions Contents Location of Controls HandsetInstallation Instructions Please Refer to the Following Diagram for Steps 4 ThroughInstallation of the Rechargeable Battery Setting the Ringer SET-UP InstructionsSetting the Language Setting the First Ring Mode Setting the Time Setting the Area Code Setting the LCD Contrast Setting the PBX Number Setting the PBX Mode Setting the Pause Time Setting the MSG Message Waiting Setting the Auto Answer Mode Setting the Private Ring Mode Setting the Unavailable Ring Mode Basic Operation Placing a CallReceiving a Call Using the Redial DEL/RE-PA Button Ending a CallOUT of Range Warning MSG Waiting Voice Mail MessagesUsing the Base page Button Using the Flash TONE/PULSE SwitchUsing the Tone Button Call Waiting Checking the Caller ID LOGDeleting ONE NAME/NUMBER from the Caller ID LOG Deleting NAMES/NUMBERS from the Caller ID LOGDialing a Number in the Caller ID Display Adding a Directory Entry Saving Caller ID Information to the DirectoryEntering a Name Using the KEY Buttons Character MAP ChartDialing a Number from the Directory Preferred Calls VIP Rejecting Blocking Calls REJEditing a Directory Entry Deleting ONE NAME/NUMBER from the Directory Troubleshooting Guide Symptom SolutionCare and Maintenance MSP-PH2400/09172CENGLISH 12/16/01, 1230 PM Memcorp, Inc Weston, FL