•You may need to change the dial type setting to Pulse dialling if your local phone exchange does not support Tone dialling.
“My call was cut off when I went out of range of the base unit. Now I cannot use my handset.”
• Please move the handset closer to the base unit.
“I hear a tone while I am using my handset, and the battery symbol on the display is “empty.”
•The battery needs to be recharged. Put the handset into the charger; it will take up to 15 hours to be fully charged.
“I’ve tried recharging the batteries, but I still get a warning that it is not charged.”
• The batteries probably need to be replaced.
“The handset does not ring when a call comes in.”
•Check that you have not set the ringing volume to “Off” (see section Setting the Ring Tone Volume).
“The Caller Display function is not working.”
•Please check if you have subscribed to the Caller Display service with your network provider.
“The Caller Display function is working but the Caller’s Name from the phonebook is not displayed even if the same phone number calls in.”
•You need to store the full phone number including the STD code into your phonebook memory.
“I have tried several times to press 
but I cannot make a call.”
•Your phone may not be registered. See section Registering Handset to Base Unit.
“The Within Range Symbol is flashing on the handset display.”
•Due to radio interference in the environment, occasional loss of synchronization between the handset and base unit may have occurred for a very short period. The base unit will quickly change to another channel automatically to overcome the interference and restore the synchronization. You can also move the handset near the base unit to reduce the interference.
EN
28