do not press 1 within 8 seconds, the machine hangs up. When you press 1, you will hear the main menu. Simply follow the instructions as announced:
‘To play all messages press 2’. ‘To play new messages press 3’.
‘To skip back during messages press 4’. ‘To delete during messages press 5’.
‘To skip forward during messages press 6’. ‘To set answer on or off press 7’.
‘To hear the outgoing message menu press 8’. ‘To set a new security code press 9’.
‘To hear main menu again press 1’.
When the last message is played you will hear, ’End of messages’.
11.2Set the security PIN code
Using the handset:
1.Press m, scroll to TAM SETTINGS and press m.
2.Scroll dto REMOTE CODE and press m. The handset will display the current code.
3.Enter a new code and then press mto confirm.
11.3 Check security code
1. Press Dat the base. The security code is announced.
36
12. Help
No dial tone
•Use only the telephone line cord supplied.
•Check that the telephone line cord is connected properly.
•Check that the mains power is connected properly and switched on.
No display
• Check that the batteries are inserted correctly and fully charged. Use only approved rechargeable batteries supplied.
• Check that the handset is switched on. Press and hold
R.
•Reset the base by removing the batteries and disconnecting the mains power. Wait for around 15 seconds before connecting it again. Allow up to one minute for the handset and base to synchronize.
icon flashes
•Handset is out of range. Move closer to the base.
•Make sure that the handset is registered to the base, see page 28.
•Check that the mains power is connected properly and switched on.
Keypad does not seem to work
• Check that the keypad lock is not on, see page 17.
Help