Memorex MPH7825 manual FCC Notice

Page 5

FCC NOTICE

The FCC requires that you be advised of certain requirements involving the use of this telephone.

1.This telephone is Hearing Aid Compatible.

2.This equipment complies with Part 68 of the FCC rules. On the bottom of this equip- ment is a label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. If requested, provide this information to your telephone company.

3.The REN is useful to determine the quantity of devices you may connect to your tele- phone line and still have those entire devices ring when your number is called. In most, but not all areas, the sum of the RENs of all devices should not exceed five (5.0). To be certain of the number of devices that you may connect to your line, as determined by the REN, you should call your local telephone company to determine the maximum REN for your calling area.

4.If your telephone causes harm to the telephone network, the telephone company may discontinue your service temporarily. If possible, they will notify you in advance. But if advance notice is not practical, you will be notified as soon as possible. You will be advised of your right to file a complaint with the FCC.

5.Your telephone company may make changes to its facilities, equipment, operations or procedures that could affect the proper operation of your equipment. If they do, you will be given advance notice so as to give you an opportunity to maintain uninterrupted service.

6.If you experience trouble with the telephone, please contact MEMCORP Inc., 3200 Meridian Parkway, Weston, FL33331, USA at 1-800-919-3647 for repair/warranty information. The telephone company may ask you to disconnect this equipment form the network until the problem has been corrected or you are sure that the equipment is not malfunctioning.

7.This equipment may not be used on coin service provided by the telephone company. Connection to party line service is subject to state tariffs.(Contact your state public utility commission or corporation commission for information).

8.WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy. If not install and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will no occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turn- ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measure:

¥Reorient and relocate the receiving antenna.

¥Increase the separation between the equipment and receiver.

¥Connect the equipment into an outlet on a circuit different from that to which the receiver needed.

¥Consult the dealer of an experienced radio / TV technician for help.

9.Some cordless phones operate at frequencies that may cause interference to nearby TVs and VCRs; To minimize or prevent such interference, the base of the cordless phone should not be placed near or on top of a TV or VCR. If interference is experienced, moving the cordless telephone farther away from the TV or VCR will often reduce or eliminate the interference.

4

Image 5
Contents MPH7825 Carton Contents Important Service InformationImportant Safety Instructions Installation Precautions Battery Safety InstructionsFCC Notice Handset Controls DescriptionControls Location and Function Base Unit Controls Mounting PositionDesktop USE Wall USEWall Mounting No Standard Wall Jack Base Retainer TABBelt Clip Instruction Base Unit Power Connection Connecting the HeadsetTelephone Operation Handset Battery InstallationInitial Setup When the Handset is OFF the Base Unit and in Standby Mode After Hearing a Busy Tone When Placing a CallIf the Handset is on the Base Unit If the Handset is OUT of the Base UnitManual Channel Scan Auto Channel ScanMaintenance Maximizing Battery LifeImproving Cordless Reception DischargingSymptoms Possible Solution / Cause TroubleshootingTechnical Information Adapter Use only with Class 2 Power Source 9VDC 300 mADistributed Exclusively by Memorex¨ MPH7825 Avertissement Renseignements Importants Pour Lentretien ET LARƒPARATION Contenu DE Lõemballage Mesures DE SƒCURITƒ Importantes Mise EN Garde PRƒCAUTIONS Ë Suivre Lors DE LinstallationAvis DU Ministere DES Comunications Honologue Parle MDCNUMƒRO DƒQUIVALENCE DE Sonnerie Commandes DU COMBINƒ Emplacement ET Fonction DES CommandesPosition DE Montage Commandes DU SocleInstallation SUR UN Bureau Installation Murale Installation DE LATTACHE-CEINTUREInstallation AU MUR sans plaque modulaire murale Languette DE RƒTENTION DU SocleInstallation DU BLOC-PILES Installation DE LalimentationRaccorder LE Casque DƒCOUTE Raccord DE Lalimentation DU Socle Mise EN GardeFonctionnement DU TƒLƒPHONE Installation InitialeSI LE COMBINƒ EST SUR LE Socle SI LE COMBINƒ EST ƒLOIGNƒ DU SocleEntrer LES NUMƒROS EN MƒMOIRE Lorsque LE COMBINƒ EST ƒLOIGNƒ DU Socle ET EN Mode DattenteRappeler UN NUMƒRO DE TƒLƒPHONE DE LA MƒMOIRE Changer LES NUMƒROS PROGRAMMƒSAMƒLIORER LA RƒCEPTION DU Sans FIL Avertissement Hors DE PORTƒEBalayage Automatique DES Canaux Balayage Manuel DES CanauxOptimiser LA DURƒE DU BLOC-PILES SOLUTION/CAUSE PossibleEntretien Guide DE DƒPANNAGEŽlectriques ou Žlectroniques DONNƒES TechniquesDistributed Exclusively By Memorp Inc