Southwestern Bell FF2128AT owner manual Contents, Important Safety Instructions

Page 2

CONTENTS

IMPORTANT SAFETY INSTRUCTIONS

 

3

SAFETY INSTRUCTIONS FOR BATTERIES

4

NAME OF CONTROLS AND INDICATIONS

5

FCC WANTS YOU TO KNOW

8

INTRODUCTION

 

FEATURES

9

BOX CONTENTS

10

PREPARATION

10

OPERATING INSTRUCTIONS

 

INSTALLATION

11

HANDSET BATTERY CHARGING

13

CALLER ID SETUP

14

TELEPHONE OPERATION

15

CALLER ID OPERATION

20

TROUBLESHOOTING

23

PRODUCT CARE

25

SERVICE

26

LIMITED WARRANTY

27

 

 

IMPORTANT SAFETY INSTRUCTIONS

BEFORE USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS, INCLUDING THE FOLLOWING:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Unplug this product from the wall telephone jack and power outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

4.Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink, laundry tub, swimming pool, or in a wet basement.

5.Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage.

6.Slots or openings in the cabinet and the back and bottom are provided for ventilation, to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, or other similar surface. This product should never be placed near or over a radiator or heat register.

7.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your dealer or local power company.

8.Do not allow anything to rest on the power cord. Do not place this product where the cord will be damaged by persons stepping on it.

9.Do not overload wall outlets and extension cords, as this can result in fire or electric shock.

10.Never push objects of any kind into this product through cabinet slots, as they may touch dangerous voltage points or short out parts. This could result in fire or electric shock. Never spill liquid of any kind on the product.

11.To reduce the risk of electric shock, do not disassemble this product. Instead, when service or repair work is required, take it to a qualified service technician. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used.

12.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged or frayed.

b.If liquid has been spilled into the product.

c.If the product has been exposed to rain or water.

d.If the product does not operate normally, and proper operating instructions have been followed, adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.

e.If the product has been dropped or the cabinet has been damaged.

f.If the product exhibits a distinct change in performance.

13.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

14.Do not use the telephone to report a gas leak in the vicinity of the leak.

15.Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

2

3

 

 

 

 

 

 

 

 

Image 2
Contents Southwestern Bell Contents Important Safety InstructionsSafety Instructions for Batteries Handset Controls, IndicatorsLCD Display Indicator Base Unit Controls and IndicatorsFCC Wants YOU to Know IntroductionPreliminary Preparation Telephone Line Installation InstallationBox Contents Desk or Table InstallationTo Replace Batteries Handset Battery ChargingWall Mounting Caller ID Setup Telephone OperationMaking a Call Receiver Volume ControlChannel AutoScan Operation Receiving a CallSpeaker volume control Memory FeatureUsing Speakerphone To Program Frequently Called NumbersCaller ID Operation Caller ID Operation Troubleshooting Product Care Service Limited Warranty