Kenwood TM-V7A instruction manual Channel Display Function, Changing Call Channel Contents Split

• The channel number is visible if using Memory Recall mode in step 1.

■Changing Call Channel Contents (Split)

1	1	Select the desired band.
2	2	Select the desired receive frequency and related

3data (Tone, CTCSS, DTSS, etc.) using VFO mode or

Memory Recall {page 31}.

4

3 Press [F], [CALL] (1 s).

5• "±" appears.

6

7

8

9

10

11

4Turn the Tuning control, or press Mic [UP]/[DWN],

12to select the desired transmit frequency.

13	5 Press [CALL] again.
14	• The selected transmit frequency is stored in the Call
15	channel, and the previous mode is restored.

Note:

16	◆	Transmit Offset status and Reverse status are not stored in a split
17		Call channel.
	◆	Lockout status is not copied from a memory channel to the Call

channel.

18

19

20

21

MEMORY a VFO TRANSFER

Transferring the contents of a memory channel or the Call channel to the VFO can be useful if you want to search for other stations or a clear frequency, near the selected memory channel or Call channel frequency.

1Recall the desired memory channel or the Call channel.

2Press [F], [VFO].

•The complete contents of the memory channel or the Call channel are copied to the VFO. VFO mode is selected after the transfer is completed.

Note: A transmit frequency from a split memory channel or split Call channel is not transferred to the VFO. To transfer a transmit frequency, press [REV], then press [F], [VFO].

CHANNEL DISPLAY FUNCTION

When this function is switched ON, the transceiver displays only memory channel numbers instead of frequencies.

Press [LOW]+ POWER ON to toggle this function ON or OFF.

2

CALL PWR

VOLSQL

1

34