Kenwood TM-V7A instruction manual Storing Data in Simplex Channels, Storing Data in Split Channels

• The arrow shows whether the current memory channel contains data ("s") or not ("u").

STORING DATA IN SIMPLEX CHANNELS

1

1Select the desired band.

22 Select the desired frequency and related data (Tone,

3	CTCSS, DTSS, etc.) using VFO mode, Memory Recall
4	{page 31}, or the Call channel {page 33}.

3Press [F].

STORING DATA IN SPLIT CHANNELS

1To select the desired receive frequency, related data and memory channel, use steps 1 to 4 (not 5) given for Simplex Memory Channels.

2Press [MR] (1 s).

• " ± " appears.

5

6

7

8

9

• A memory channel number and an arrow appear.

3 Select the desired transmit frequency.

10

11

124 Turn the Tuning control, or press Mic [UP]/[DWN], to

select the desired memory channel.

13

5Press [MR].

14 • The selected frequency and related data are stored in the

15memory channel. The transmit frequency from a split memory channel or split Call channel is not stored.

16 • If the memory channel selected in the previous step

17already contained data, the new data overwrites the previous data.

18

19

20

21

4 Press [MR].

• The selected transmit frequency is stored in the memory

channel.

Note:

◆If you select an offset direction in step 1, you can also press [REV] in step 3 to select a transmit frequency. The transmit frequency separated by the current offset frequency will be stored in the memory channel.

◆In step 2 you cannot use Mic [MR], or Mic [PF] programmed with Memory Recall.

◆Transmit Offset status and Reverse status are not stored in a split memory channel.

30