Southwestern Bell FF2128AT Safety Instructions for Batteries, Handset Controls, Indicators

Page 3

SAFETY INSTRUCTIONS FOR BATTERIES

NAME OF CONTROLS AND INDICATIONS

Safety Instructions for Batteries

Handset Battery Pack

CAUTION:

Use only a Southwestern Bell Freedom Phone® approved battery pack in the handset of your FF2128 Cordless Telephone. To reduce the risk of fire or injury, always do the following when replacing, discarding or charging batteries. When handling the batteries, be careful not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conducting material may overheat and cause burns.

Use only the following type and size of battery pack:

FOR HANDSET UNIT :

a.GP40AAK3BMX 3.6V 400mAHr, GPI International Ltd or

b.BYD D-2/3AA400x3 3.6V 400mAHr, BYD Battery Co.,Ltd or

c.JB40AA2/3N3BMX 3.6V 400mAHr, JB Energy (HK) Ltd.

CONTAINS NICKEL-CADMIUM

BATTERY. BATTERY MUST BE

RECYCLED OR DISPOSED OF

PROPERLY.

a.Do not dispose of the battery pack in a fire. The cell may explode. Check with local codes for possible special disposal instructions.

b.Do not attempt to open or mutilate the battery pack. The chemicals are dangerous and may cause damage to the eyes or skin, and may be toxic if swallowed.

c.Follow the charge instructions outlined in this manual. (See page 13)

The EPA certified RBRC®* Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates that Southwestern Bell Freedom Phone® Retail Sales is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your areas. Please call 1- 800-8-BATTERY for information on Ni-Cd battery recycling and disposal bans /

Handset Controls, Indicators

Receiver Volume

Switch

To adjust the receiver volume level

Ringer On/Off Switch

New Call Indicator

Flashes to indicate there are calls that have not been reviewed

Caller ID Calls Button

Used to dial the displayed number

Memory Button

Used to store or recall numbers in memory

Keypad

Number buttons

Antenna

Earpiece

LCD Display

Delete Button

Used for deleting Caller

ID entries

Flash Button

Used to access call waiting (if available)

Headset Jack

Talk Button

Used to make or to terminate calls

restrictions in your area. Southwestern Bell Freedom Phone® Retail Sales’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources.

*RBRC® is a trademark of the Rechargeable Battery Recycling Corporation.

Save These Instructions

4

Redial Button

Redials the last number or adds a pause

Channel Button

Used to select another channel for clearer reception

Caller ID Review

Buttons

Memory scroll buttons

Intercom Button

Microphone Ringer

5

Image 3
Contents Southwestern Bell Important Safety Instructions ContentsHandset Controls, Indicators Safety Instructions for BatteriesBase Unit Controls and Indicators LCD Display IndicatorIntroduction FCC Wants YOU to KnowDesk or Table Installation InstallationBox Contents Preliminary Preparation Telephone Line InstallationHandset Battery Charging Wall MountingTo Replace Batteries Telephone Operation Caller ID SetupReceiving a Call Receiver Volume ControlChannel AutoScan Operation Making a CallTo Program Frequently Called Numbers Memory FeatureUsing Speakerphone Speaker volume controlCaller ID Operation Caller ID Operation Troubleshooting Product Care Limited Warranty Service