Southwestern Bell GH3210 owner manual Intercom, Call Transfer Calltransfer, Memory Feature

Page 22

TELEPHONE OPERATION (CONT.)

Intercom

INTERCOM

set will change from “TALK” to “TRANS- FER H1>H2” or “TRANSFER H2>H1”. Likewise, from Stand-by to “CALL TRANSFER” at the transferred handset.)

1.Press INT/TRAN button while in Stand- by mode.

2.The LCD display of the other handset will show “INTERCOM” with a beep sound.

3.Press INT/TRAN (or TALK) button from the called handset to establish intercom between handsets.

4.Press INT/TRAN (or TALK) button from either one of the handset to terminate the Intercom. Both of the handsets will go to Stand-by mode.

NOTE:

If there is no response from the called handset within 30 seconds, the calling handset goes back to Stand-by mode.

Call Transfer CALLTRANSFER

1.Press INT/TRAN button while in TALK mode.

2.The LCD display will show “INTERCOM

H1>H2” or “INTERCOM H2>H1” with a beep sound.

3.Press TALK or INT/TRAN button from the transferred handset to take the call. (The LCD display of the transferring hand-

NOTE:

If there is no response from the trans- ferred handset within 15 seconds, the LCD display of the transferring handset will show “RING BACK” with a beep sound. The transferring handset goes back to TALK mode.

Memory Feature

Your GH3210 is equipped with 10 memo- ries for programming your most frequently dialed telephone numbers. You can store up to 15 digits in each of the memory loca- tions 0 through 9 by following the steps outlined.

A record of the numbers to be speed- dialed may be kept on the memory index chart shown at the later part of this man- ual.

22

Image 22
Contents Toll Free Helpline Cordless Dual Handset Telephone With Call Waiting Caller IDContents Important Safety Instructions Safety Instructions for Batteries Safety Instructions for Batteries Handset Battery PackHandset Controls, Indicators Name of Controls and IndicationsLCD Display Indicator DC In 9v DC 500mA Base Unit Controls and IndicatorsTelephone Line ButtonCharger Unit Controls and Indicators FCC Wants YOU to KnowPage Introduction About the GH3210Preliminary Preparation / Telephone Line Installation Box ContentsModular Outlet Installation Desk or Table InstallationExtra Charger Installation Belt clip installationDo not Connect the AC Adaptor to the Wall Power Outlet YET Wall MountingHandset Battery Charging To Replace BatteriesHandsets ID Registration To Set Contrast Setup HandsetOverview To Set Ringer On/OffTo Set Area Code To Set Tone/Pulse ModeTo Set Time and Date Digital Security System Receiver Volume ControlTelephone Operation Channel AutoScan OperationMaking a Call Receiving a CallConference Out of RangeFlash Page/Handset LocatorIntercom Memory FeatureIntercom Call Transfer CalltransferRedial To Program Frequently Called NumbersTo Change a Stored Number To Retrieve Stored NumbersReceiving Call Waiting Caller ID Caller ID OperationJOE Smith Reviewing New Call RecordsCaller ID Erase To Erase a Single Call Caller ID RedialTo Store a Caller ID Number to Memory To Erase All CallsPress the FLASH/DEL button. All viewed calls will be erased Trouble Shooting Static noise is present Conversation is interruptedFrequently or During conversationProduct Care Speed Dialing Numbers Index Additional InformationService For IN-WARRANTY ServiceLimited Warranty Southwestern Bell Freedom Phone Retail Sales Help Line AT