TROUBLE SHOOTING
If your GH3210 is not performing to your expectation, please try these simple steps.
PROBLEM |
| SUGGESTION | |
|
| ||
| Make sure the AC Adapter is plugged into | ||
Charge light won’t come | the base unit and wall outlet. | ||
Make sure the wall outlet is functioning. | |||
on when handset is placed | |||
Make sure the handset is properly seated in the | |||
in the base unit. | |||
base unit. |
| ||
|
| ||
| Make sure the rechargeable battery pack | ||
| is properly connected in the handset. | ||
|
| ||
| Charge the handset for 10 hours before initial | ||
| use. |
| |
No dial tone | Place the handset back into base cradle for | ||
5 seconds | . | ||
| |||
| Make sure the handset is fully charged. | ||
| The IN USE/CHARGE LED should light | ||
| when the handset is in the cradle. | ||
|
| ||
| Make sure the Tone/Pulse mode is set to the | ||
Can’t make outgoing calls | correct setting. If set to the Tone mode, try | ||
to switch to Pulse mode . You may have | |||
| |||
| pulse dialing service. | ||
|
| ||
| Make sure the Ringer On/Off selection on the | ||
| software of the handset is set to the “ On” | ||
| position. |
| |
| Rechargeable battery pack may be weak or | ||
| not fully charged. Charge the battery pack for | ||
|
| ||
| The handset may be too far away from the | ||
| base unit. |
| |
Handset doesn’t ring | Make sure the AC adaptor is plugged into the | ||
| base unit and wall outlet. | ||
| Make sure the wall outlet is functioning. | ||
| There may be too many telephones installed on | ||
| the same line. Contact your local telephone | ||
| company to determine the maximum number of | ||
| extensions for your calling area. | ||
| Place the handset back to base for 5 seconds. | ||
|
| ||
Caller’s voice is too low | Adjust the receiver Volume Control | ||
on the handset to higher level. | |||
| |||
|
| ||
LCD reads | Handset needs to be registered with the base | ||
unit. |
| ||
‘ No link’ | See handset registration on page 16 or on main | ||
base label. |
| ||
|
| ||
|
|
| |
27