TELEPHONE OPERATION (CONT.)
Making a Call | Temporary Tone Mode |
PAUSE |
1.If one handset is in use, the other hand- set will display “LINE IN USE” for 3 sec- onds when TALK button is pressed.
2.Lift the handset and press the TALK button to be connected to the phone line. The LCD display will show “TALK” and the TALK timer will start. The IN USE/ CHARGE LED on the base will light.
3.After hearing a dial tone, dial the de- sired number. Or you may predial the num- ber (without pressing the TALK button), then press the TALK button.
4.If you misdial, simply press the TALK button, wait for a couple of seconds, and
press the TALK button again for a new dial tone.
5.After your conversation is completed, press the TALK button once to discon- nect the line, or return the handset to the base.
Receiving a Call
When the phone rings:
1.IF THE HANDSET IS OUT OF THE CRADLE, press the TALK button.
2.IF THE HANDSET IS IN THE CRADLE, lift the handset. DO NOT press the TALK button, as you will be connected automat- ically.
20
In Pulse dialing mode, you can access bank facilities, telephone answering machines, etc., by simply pressing the TONE(‘
’key) to get into the tone mode and input the required tone codes. It will reset automati- cally after you end your call. By pressing the FLASH button, you can return to the pulse mode during the call.
NOTE:
If you experience difficulty with placing or receiving calls, a lost security code may be the cause of the problem. When this occurs, the handset can no longer com- municate with its base. The loss of the code can occur any of the following ways: if the battery is drained and needs recha- rging; the handset is out of range of the base unit; the AC adaptor is disconnected or a power loss has occurred; or anthing that causes electrical interference,for ex- ample multiple cordless telephones, baby monitors, televisions, VCR’s etc. Reset the security code by placing the handset on the base for 10 seconds. If that does not work, make sure the AC adaptor is connected. If necessary, unplug the AC adaptor from the power source. Discon- nect the battery for 5 seconds and then reconnect. Place the handset on the base and then replug the AC adaptor (see Troubleshooting).