Sony CD145 Install rechargeable Batteries, Slide out the battery cover Place the batteries as

Page 15

Note

The line adaptor may not be attached to the line cord. In this case, you have to connect the line adaptor to the line cord first before plugging the line cord to the line socket.

3.2Install rechargeable

batteries

Your CD145 is supplied with two rechargeable batteries. Before using the handset, install the batteries into the handset and fully charged them up.

1Slide out the battery cover

2Place the batteries as

indicated in the battery compartment and replace the battery cover.

3.3Place the handset on

the charging cradle Charge the handset for at least 24 hours before using it for the first time.

When the battery is fully charged, the talk time of your CD145 is approximately 12 hours and the standby time is approximately 120 hours.

1Place the handset on the charging cradle of the base station.

2When the handset is fully

charged,

is displayed.

3.4Configure your

phone

Before using your CD145, you need to configure it according to the country of use.

Depending on your country, country selection screen may not appear. In that case, you do not need to select the country code to configure your phone. After charging it for a few minutes, the country code selection screen appears. Follow these steps to configure your phone:

Getting started

13

Image 15

Contents EN Digital Cordless Telephone CD145Page Table of contents How to change the remote PIN Default settings Frequently asked questionsAnswering machine Easily accessible Power requirementsNational recovery & recycling system Use one of the following disposal optionsDisposal instructions for batteries Electric, Magnetic and Electromagnetic Fields EMF Using GAP standard compliancePage Batteries What’s in the boxTelephone handset Base station Line cordRedial/Flash key Overview Phone Handset ACall Log keyPhonebook key Talk keyProgram key Alphanumeric keypad GStar keyHHash key Call Transfer / Intercom / ConferenceDisplay icons on the handset + / key Delete key Base stationBackward key Event LED Forward keyConnect the base Station Getting startedInstall rechargeable Batteries Slide out the battery cover Place the batteries asConfigure your Phone Country setting table PressAppear on the screen Tip Call from the call Log Make a call PrediallingCall is initiated Direct diallingEnd a call Call from the phonebookCall from the redial list Display shows the last number dialledRecall How to make a second call During a callHow to answer a Second call How to use IntercomConference call is initiated How to make an Internal callPress on the called handset Called handset rings if it is availableHow to find a handset During the conference callExternal call is put on hold automatically Number is saved Selected memory location How to adjust earpiece volume During a callCall in progress Mute/Unmute microphone During a call Is shown on the displayAll the phonebook entries are deleted How to access the phonebook Idle modeHow to edit the phonebook entry or Delete a number How to delete the entire phonebookSettings How to set the time 1 Press How to access the call logHow to delete the entire call log How to access the redial listHow to select recall Time How to set the ring VolumeHow to set How to activate/deactivate Keypad lockHow to set the auto prefix How to select dial ModeCurrent settings are displayed How to turn on/turn off the key ToneNew PIN is saved How to change the master PINHow to program voice mailbox number How to access your voice mail numberYour phone is reset to its default settings How to restore to default settingsHow to turn off How to set answer delayHow to record your outgoing message Country setting table on Section How to play Outgoing messageHow to delete outgoing message How to select the default outgoing MessageIncoming messages How to playHow to screen an incoming call How to remotely access yourPress and hold for two Seconds to delete all old messages How to change the remote PIN New remote access PIN Is savedKeys Description Items Default values Default settingsPoor audio quality Connection Handset does not switch onPhone does not work at all Communication is lost during a callHandset displays nothing, but only the is blinking AppearsSet-up Caller ID does not work properly Call Waiting call cannot be answeredHandset is unable to register Caller does not hear meNoise interference on your radio or television Phonebook entry cannot be storedUnable to perform remote operation